Installation Process

Setting SCSI Device IDs

9.Set the SCSI ID on the disk drives: ID 7 is reserved for the controller.

☛Note

Each drive must have a unique ID chosen from 0 through 6 or 8 through 15. Be careful not to duplicate a drive address on the same channel.

Remember: ID 7 is reserved for the controller; therefore, it cannot be used as a disk drive ID.

ID’s from 0 through 6 are usually for Narrow,

8-bit devices. However, the full range of SCSI ID addresses, 0 through 6 and 8 through 15 can be used for Wide, 16-bit devices.

See your device documentation for instructions on how to set your particular disk drive’s SCSI address.

SCSI ID Numbers

7 is reserved for the controller

Figure 2-13. SCSI ID Numbers

2-16

AcceleRAID 352 Installation Guide