POST Error and Beep Codes
NOTE: Perform the FRU replacement or actions in the sequence shown in FRU/Action column, if the FRU replacement does not solve the problem, put the original part back in the computer. Do not replace a
The error messages in the following table indicate the BIOS signals on the screen and the error symptoms classified by functions. If the symptom is not included on the list, please refer to “Undetermined Problems”.
NOTE: Most of the error messages occur during POST. Some of them display information about a hardware device, e.g., the amount of memory installed. Others may indicate a problem with a device, such as the way it has been configured.
NOTE: If the system fails after you make changes in the BIOS Setup Utility menus, reset the computer, enter Setup and install Setup defaults or correct the error.
POST Code (Hex) |
| POST Routine Description |
|
| |
CFh | Test CMOS R/W functionality | |
|
| |
C0h | Early chipset initialization | |
|
| Disable shadow RAM |
|
| Disable L2 cache (socket 7 or below) |
|
| Program basic chipset registers |
|
| |
C1h | Detect memory | |
|
| |
|
| |
|
| |
C3h | Expand compressed BIOS code to DRAM | |
|
| |
C5h | Call chipset hook to copy BIOS back to E000 and F000 shadow RAM | |
|
| |
01h | Expand the X group codes locating in physical address 1000:0 | |
|
| |
02h | Reserved | |
|
| |
03h | Initial Superio_Earl_Init switch | |
|
| |
04h | Reserved | |
|
|
|
05h | 1 | Blank out screen |
| 2 | Clear CMOS error flag |
|
| |
06h | Reserved | |
|
|
|
07h | 1 | Clear 8042 interface |
| 2 | Initialize 8042 |
|
|
|
08h | 1 | Test special keyboard controller for Winbond 977 series Super I/O chips |
| 2 | Enabled keyboard interface |
|
| |
09h | Reserved | |
|
|
|
0Ah | 1 | Disable PS/2 mouse interface (optional) |
| 2 | Auto detect ports for keyboard and mouse followed by a port and interface swap |
|
| (optional) |
| 3 | Reset keyboard for Winbond 977 series Super I/O chops |
|
| |
0Bh | Reserved | |
|
| |
0Ch | Reserved | |
|
| |
0Dh | Reserved | |
|
| |
0Eh | Test F000h segment shadow to see whether it is rewritable or not. If test fails, keep | |
| beeping the speaker. | |
|
| |
0Fh | Reserved | |
|
| |
10h | Auto detect flash type to load appropriate flash rewritable codes into the run time | |
| area in F000 for ESCD & DMI support. | |
|
| |
11h | Reserved | |
|
|
|
Chapter 4 | 61 |
