Acer M5150 manual Power Management Setup, Acpi Suspend Type S3 STR, Deep Power Off Mode Enabled

Power Management Setup

This page sets up some parameters for system power management operation.

CMOS Setup Utility

Power Management Setup

Power Management Setup			Item Help
ACPI Suspend Mode	S3 (STR)
Deep Power off mode	Enabled		Select the ACPI
Power On by RTC Alarm	Disabled		state used for
			System Suspend.
Power On by PCIE Devices	Disabled
Power On by PCI Devices	Disabled
Wake Up by PS/2 KB/Mouse	Enabled
Wake Up by USB KB/Mouse	Enabled
Restore On AC Power Loss	Last State
↑↓：Move Enter：Select +/-/：Value		F10：Save ECS：Exit
F1：General Help	F9：Load Default Settings

ACPI Suspend Type (S3 (STR))

Use this item to define how your system suspends. In the default, S1 (POS), the suspend mode is equivalent to a software power down. If you select S3 (STR), the suspend mode is suspend to RAM, i.e., the system shuts down with the exception of a refresh current to the system memory.

Deep Power Off Mode (Enabled)

Under ACPI (Advanced Configuration and Power management Interface) you can create a software power down. In a software power down, the system can be resumed by Wake Up Alarms. This item lets you install a software power down that is controlled by the power button on your system. If the item is set to Instant-Off, then the power button causes a software power down. If the item is set to Delay 4 Sec, then you have to hold the power button down for four seconds to cause a software power down.

Power On by RTC Alarm (Disabled)

The system can be turned off with a software command. If you enable this item, the system can automatically resume at a fixed time based on the system’s RTC (realtime clock). Use the items below this one to set the date and time of the wake-up alarm. You must use an ATX power supply in order to use this feature.

Power On by PCIE/PCI Devices (Disabled)

The system can be turned off with a software command. If you enable this item, the system can automatically resume if there is an incoming call on the PCIE LAN card. You must use an ATX power supply in order to use this feature. Use this item to do wake-up action if inserting the PCIE card.

26