RMC 7132
1U Rackmount System
2-5 Checking the Motherboard Setup
After you install the RMC7132 in the rack, you will need to open the unit to make sure the serverboard is properly installed and all the connections have been made.
Accessing the Inside of the System (Figure
1.First, grasp the two handles on either side and pull the unit straight out until it locks (you will hear a "click").
2.Next, depress the two buttons on the top of the chassis to release the top cover. There is a large rectan- gular recess in the middle front of the top cover to help you push the cover away from you until it stops.
3.You can then lift the top cover from the chassis to gain full access to the inside of the server.
Checking the Components
1. You may have one or two processors already installed into the system board.
Each processor should have its own heatsink attached. See Chapter 5 for instructions on processor and heatsink installation.
2.Your RMC7132 server system may have come with system memory already installed. Make sure all DIMMs are fully seated in their slots. For details on adding system memory, refer to Chapter 5.
3.If desired, you can install an
4.Make sure all power and data cables are properly connected and not blocking the airflow. See Chapter
5for details on cable connections.
5.Check the air seals for damage. The air seals are located under the blower fan and beneath the frame cross section that separates the drive bay area from the serverboard area of the chassis.
| © Copyright 2005 Acnodes, Inc. |
661 Brea Canyon Rd., Suite 3 | All rights reserved. Product description and product specifications |
Walnut, CA 91789 | are subject to change without notice. For latest product information, |
tel: 909.598.7388, fax: 909.598.0218 | please visit Acnodes’ web site at www.acnodes.com. |
