Acnodes RMC 7132 Installing Memory Modules, Installing & Removing DIMMs, To Install, To Remove

RMC 7132

1U Rackmount System

5-6 Installing Memory Modules

Note: Check the Supermicro web site for recommended memory modules.

Installing & Removing DIMMs

1.Insert the desired number of DIMMs into the memory slots, starting with DIMM #1A. For best performance, please use the memory modules of the same type and same speed in the same bank. See the DIMM Installation Chart on the following page. 2. Press down the release tabs on the ends of a memory slot. Insert each DIMM module vertically into its slot. Pay attention to the notch along the bottom of the module to prevent inserting the DIMM mod- ule incorrectly.

3.Gently press down on the DIMM module until it snaps into place in the slot. Repeat for all modules.

4.Reverse the steps above to remove the DIMM mod- ules from the motherboard.

To Install:

Insert module vertically and press

down until it snaps into place. Pay atten- tion to the alignment notch at the bottom.

To Remove:

Use your thumbs to gently push the release tabs near both ends of the module. This should release it from the slot.

	© Copyright 2005 Acnodes, Inc.
661 Brea Canyon Rd., Suite 3	All rights reserved. Product description and product specifications
Walnut, CA 91789	are subject to change without notice. For latest product information,
tel: 909.598.7388, fax: 909.598.0218	please visit Acnodes’ web site at www.acnodes.com.