Acnodes RMC 7132 Checking the Drive Bay Setup, Checking the Drives, Checking the Airflow

RMC 7132

1U Rackmount System

2-6 Checking the Drive Bay Setup

Next, you should check to make sure the peripheral drives and the Serial ATA drives and Serial ATA backplane have been properly installed and all essential connec- tions have been made.

Checking the Drives

1.All drives can be accessed from the front of the server. For servicing the DVD-ROM and floppy drives, you will need to remove the top chassis cover.

2.Refer to Chapter 6 if you need to reinstall a DVD-ROM and/or floppy disk drive to the system.

3.Depending upon your system's configuration, your system may have one or two Serial ATA drives already installed. If you need to install Serial ATA drives, please refer to the appropriate section in Chapter

Checking the Airflow

1.Airflow is provided by two 10-cm input fans. The system component layout was carefully designed to promote sufficient airflow through the small 1U rackmount space.

2.Note that all power and data cables have been routed in such a way that they do not block the airflow generated by the fans.

Providing Power

1.The last thing you must do is to provide input power to the system. Plug the power cord from the power supply unit into a high-quality power strip that of- fers protection from electrical noise and power surges. It is recommended that you use an uninterruptible power supply (UPS).

2.Finish by depressing the power button on the chassis control panel.

	© Copyright 2005 Acnodes, Inc.
661 Brea Canyon Rd., Suite 3	All rights reserved. Product description and product specifications
Walnut, CA 91789	are subject to change without notice. For latest product information,
tel: 909.598.7388, fax: 909.598.0218	please visit Acnodes’ web site at www.acnodes.com.