Acnodes RMC 7150

All r ights reserv ed. Product descr iption and produ ct specific ations

are sub ject to c hange without not ice. For latest product in formation,

please visit Acnode s’ we b si te a t ww w.acnodes. com.

PC 5150

15-inch touch panel PC

14628 Central Blvd,

Chino, CA91710

tel:909.597.7588, fax:909. 597.1939

RMC 7150

14” short depth rack server

6-4 Drive Bay Installation/Removal

Accessing the Drive Bays

DVD-ROM/Serial ATA Drives: For installing or removing the DVD-ROM or SATA drive, you will need to gain access to the

inside of the server by removing the top cover of the chassis. Note: Only a "slim" DVD-ROM will fit in the 6016T-MR.

Serial ATA Drive Installation

The SATA drive is not hot-swappable, meaning system power must be turned off before installing or removing.

1. First power down the system and then remove the top cover of the chassis as described on page 6-7.

2. Unscrew the retention screw at the top center of the drive, then push the drive tray out from the back until you can grasp

and pull it out through the front of the chassis.

3. Remove the drive from the drive tray.

4. To add a new SATA drive, install a drive into the tray with the printed circuit board side facing down and so that the

mounting holes align with those in the tray.

5. Secure the drive to the tray with the four screws.

6. Replace the top cover when finished. See Figure 6-3.

Note: it can accommodate two internal SATA hard drives, one on each side of the fans.