Acoustic Research AWD205 Charging The Headset, Buttons & Jacks, Turning the Headphones Off

BUTTONS & JACKS

Turning the Headphones Off

Put the On/Off switch in the Off position. Don’t forget to unplug the transmitter too!

CHARGING THE HEADSET

If you are using rechargeable batteries NiMH or NiCd (such as the batteries provided), the batteries will charge when the headphones are connected to the transmitter using the charging cable.

WARNING: To avoid risk of fire or injury, DO NOT connect the headphones to the transmitter with the charging cable if you installed alkaline or other non-rechargeable batteries – this could cause the batteries to leak, which would damage the headphones.

Transmitter (back panel)

Charging

cable

Left headphone

Notes about charging:

To charge the headset unit:

1.Plug one end of the charging cable to the Charge jack on the transmitter’s back panel. (Make sure the transmitter is plugged in!)

2.Plug the other end of the charging cable into the Charge jack on the left headphone.

While the headphones are charging, the Charge indicator on the transmitter’s front panel remains red. This LED turns off when the headphones are fully charged.

•When the batteries are charged, remember to unplug the charging cable from the headphones and transmitter.

•Never leave the batteries charging for more than 48 hours.

•The batteries should be charged for a full 8 hours.

8