Jensen JiMS-525i instruction manual Using Headphones not Included, Clock Setting, Setting the Time

USING HEADPHONES (NOT INCLUDED)

Inserting the plug of your headphones (not included) into the Headphone jack, on the back of the Radio, will enable you to listen in private. When using headphones, the speakers will be disconnected automatically.

NOTE: READ THIS IMPORTANT INFORMATION BEFORE USING YOUR HEADPHONES

1.Avoid extended play at very high volume as it may impair your hearing.

2.If you experience ringing in your ears, reduce the volume or shut off your unit.

3.Keep the volume at a reasonable level even if your headset is an open-air type designed to allow you to hear outside sounds. Please note that excessively high volume may still block outside sounds.

CLOCK SETTING

The following procedures can be accomplished by using either the remote or the controls on the main unit.

Setting the Time

The Clock can only be set in POWER off mode.

1.Press and hold the SET Button for 2 seconds and the Hour digits of the clock will flash.

2.Press the : or 9 Buttons until the correct Hour digits appear in the LCD.

Note: Make sure the hour is set so that AM or PM is correctly displayed. It is important that the "AM" or "PM" setting is correct for proper operation of the Alarm function.

3.Press the SET Button to confirm. Minute digits will appear and flash in the LCD.

4.Press the : or 9 Buttons to set the Minute digits.

5.Press the SET Button to exit and activate the new clock time to operate.

- 17 -