Specify a Static IP Address | Actiontec electronic GT701WG manual

Actiontec 54 Mbps Wireless DSL Gateway User Manual

Specify a Static IP Address

Select this option if the ISP service is configured to use RFC 1483 Bridged or Routed using a Static IP Address. Enter the IP Address, Subnet Mask, and Default Gateway Address provided by the ISP in the “Broadband Connection via Static IP Address” screen, which causes the IP address and routing information to termi- nate at the Gateway, as opposed to the IP address and routing information being bridged to terminate at the computer. This allows the use of the router capabilities for the Local Area Network (LAN).

☞Note: Contact the ISP if unsure of the proper configuration.

Encapsulation

If the Gateway is configured to obtain an IP address through DHCP or to specify a static IP address, select the appropriate encapsulation option used by the ISP (RFC 1483 Bridged or RFC 1483 Routed).

☞Note: Contact the ISP if unsure of the proper configuration.

Unnumbered Mode/VIP Mode

If a block of public static IP addresses was purchased from the ISP, select Unnumbered Mode by clicking in the appropriate check box. Then, enter the IP Address and Subnet Mask in the “Gateway Address” and “Unnumbered Subnet Mask” text boxes below the “Unnumbered IP Address.” Click Next, then click Save and Restart to make all changes permanent.

42

Image 45

Actiontec electronic GT701WG user manual Specify a Static IP Address

Contents

Wireless DSL Gateway Table of Contents Troubleshooting Setting Up a NetworkSetting Up Static IP on the Computer Specifications 111 Introduction1 Package Contents Minimum System Requirements Features Introduction Power Light Getting to Know the GatewayDSL Light Internet Light Wireless LightEthernet Light USB Light Power Port Reset SwitchPhone Port USB Port Connecting a Computer to the Gateway Setting Up GatewayPage Setting Up the Gateway Get the Gateway from the kit, then click Next Setting Up the Gateway Page Setting Up the Gateway Page Connecting Via USB Page Setting Up the Gateway Page Setting Up the Gateway Page Setting Up the Gateway Installing Phone Filters Setting Up the Gateway Page Setting Up the Gateway Click Next Ethernet Setting Up the Gateway Next, go to Setting Up the DSL Connection, below Setting Up the DSL Connection Setting Up the Gateway Page Gateway is successfully configured and ready for use Installation Buddy checks the configuration of the Gateway This page left intentionally blank Performing a Basic Setup Basic SetupTo configure the Gateway for basic operation Page Performing a Basic Setup Click Save and Restart at the bottom of the screen Changing the Admin User Name and Password Using Advanced Setup Accessing Advanced SetupTo access the Advanced Setup configuration screens Page WAN IP Address Obtain an IP Address through PPPoE or PPPoA Transparent Bridging Encapsulation PPPoA only PPP Auto Connect Specify a Static IP Address Using Advanced Setup Channel Wireless Settings WEP Off WEP+802.1x WPA Wireless MAC Authentication Wireless Advanced Settings Dhcp Server LAN IP Address Ending IP Address Beginning IP Address Services Blocking DNS Dynamic or StaticDNS Server Website Blocking Remote Management Port Forwarding DMZ Hosting Dynamic Routing Firewall Static Routing NAT Network Address Translation UPnP Universal Plug and Play Status Viewing Gateway’s SettingsPage WAN Status Routing Table Active User List LAN Status Web Activity Log Using Utilities Restore Default Settings DSL Settings Upgrade Firmware This page left intentionally blank Ethernet Setting Up a NetworkPage Setting Up a Network Page Setting Up a Network USB Setting Up a Network Page Setting Up a Network Page Wireless Page Read the on-screen instructions, then click Finish This page left intentionally blank Troubleshooting TroubleshootingCannot Use the Internet Physical Connections Connection to the Internet Frequently Asked QuestionsWhich protocols does the Gateway support? Which connection speeds does the Gateway support? Yes, the Gateway has a built-in DSL Modem Wireless Is the Gateway flash-upgradeable? How do I do it?Which wireless cards will work with the Gateway? Will my Xbox work with the Gateway? How do I find out which IP address my computer is using? What is the valid IP range I can use for my home network? Yes, if the application is designed to run over a network What is NAT and how does it protect my network? What is the default username for the Gateway?How many computers can be connected through the Gateway? Does the Gateway function as a firewall? Locating Computer Information Reference Locating Windows Operating System Files Appendix a Reference Click Search Windows 98 SE Setting Up Static IP On the ComputerPage 192.168.0.2 Enter the following address in the Subnet mask text box Windows Me Appendix B Setting Up Static IP on the Computer 192.168.0.2 Windows Page Appendix B Setting Up Static IP on the Computer 100 Windows XP 102 103 104 105 106 Computer Security Comparing DSL Service with a Dial-Up Modem Gateway Security Computer SecurityInternet Browsers Electronic Security 110 General Specifications DLite T1.413 RFC 1483, 2364 Protocol WAN PPP, DHCP, Static IP LED Indicators Wireless Operating RangePower, DSL, Internet, Ethernet, USB, Wireless Environmental Glossary Access Point 114 Ssid 116 High Security Level Firewall Security Level Services Table Low Security Level Medium Security Level Basic Security Level Service Acronym Definitions Icmp Real audio/video323 120 Classic Non-Windows G System Setup 122 Appendix G Non-Windows Setup 124 Installation Buddy Settings Default Mode PPPoA Default VPI Default VCI Regulatory Compliance Notices ModificationsClass B Equipment All other names are the property of their respective owners Miscellaneous Legal Notices 129 Limited Warranty 130 Limited Warranty 132