adaptec | ||
|
|
|
Problems Booting the System from a SCSI Drive
∙Make sure that both standard fixed disks are mapped out of the system.
∙Make sure that the SCSI boot drive address is set to SCSI ID 0:0. Check the drive installation manual for informa- tion about setting the SCSI ID for that device. The Return Installed Devices utility in the Onboard utilities can also be used to determine the SCSI addresses of pe- ripherals on the SCSI bus.
∙Make sure that SCSI parity is consistently enabled or dis- abled on all devices on the SCSI bus.
∙Verify the proper installation and configuration of the host adapter and SCSI devices.
∙Power should be cycled OFF and ON after changing any values on a host adapter, setup program, or SCSI device, to be sure that a DOS format operation has been success- fully completed.
∙Make sure that the SCSI bus is properly terminated.
∙Make sure that the intended boot disk has an active DOS partition and a DOS format.
∙Check the cabling.
Problems Using a SCSI and a Standard Disk Drive
The drives are configured as SCSI disk drive D and standard disk drive C.
∙Make sure that the second standard fixed disk is mapped out of the system.
