Setting Up the WAN
2Select a session by typing the session number at the Select session for editing prompt to display the WAN Session Options screen.
1. | Session Name | Bridge | 10. | VPI | 0 |
2. | WAN Protocol | RFC1483 Bridge | 11. | VCI | 35 |
3. | State | Enabled | 12. | QOS | UBR |
4. | IP Addressing | N/A | 13. | QOS Peak Cell Rate |
|
5. | IP Address | N/A | 14. | Encapsulation | LLC |
6. | IP Net Mask | N/A | 15. | Login Name | N/A |
7. | NAT | N/A | 16. | Login Password | N/A |
8. | RIP Send | N/A | 17. | Authentication | N/A |
9. | RIP Accept | N/A | 18. | Apply |
|
| Select | parameter to edit (Return to exit) |
| ||
|
|
|
|
|
|
3Type 1 to select the Session Name then type a session name.
4Type 10 to select the VPI parameters then enter the values supplied by your service provider.
5Type 11 to select the VCI parameters then enter the values supplied by your service provider.
6If you are operating in Router mode, you also need to enter the WAN IP address and the associated WAN IP subnet mask. Both of these values are provided by your service provider.
7Type 18 to immediately activate the changes that you have made for this session.
8Select Save New System configuration from the Main Menu as described in “Saving the Current Configuration” on page 60 or the changes will be lost upon reboot or power cycle.
46 | MM701F User Manual |