Setting Up the WAN
SETTING UP THE LANIf you are operating in Router mode and in a LAN environment, then you also need to set your LAN protocol, Ethernet Port IP address, and subnet mask.
If you prefer, you may use the default values of 10.0.0.1 for the Ethernet Port IP Address, and 255.255.255.0 for the subnet mask.
1From the Main Menu, select LAN Setup. The LAN setup screen displays.
|
| LAN |
1. | LAN Protocol | Bridge |
2. | IP address | 10.0.0.1 |
3. | IP Net Mask | 255.255.255.0 |
4. | Default Gateway |
|
5. | DHCP | None |
6. | DHCP Range Low Address | N/A |
7. | DHCP Range High Address | N/A |
8. | DHCP Gateway Address | N/A |
9. | DHCP DNS | N/A |
10. | Apply |
|
Select Parameter to edit (Return to exit)
2From the LAN Setup menu, select LAN Protocol by typing 1.
3Do one of the following from the LAN Mode menu:
•Type 1 to select Router.
•Type 2 to select Bridge. You must configure an IP address for the LAN port to use a Browser or Telnet to manage the MM701F.
4From the LAN Setup menu, type 2 or 3 to select IP Address or IP Net Mask (respectively), then enter the values supplied by your LAN administrator or use the default values.
5From the LAN Setup menu, type 4 to select Default Gateway, then enter the Default Gateway IP address supplied by your access provider.
6From the LAN Setup menu, type 10 to select Apply. Apply immediately activates the changes that you have made for this session.
7From the Main Menu, type 5 to select Save New System Configuration and save these settings.
48 | MM701F User Manual |