Adcom GFR-700 Speaker Connections, Connecting Speakers, “Banana” plug connection, Right, Left

Chatper 2 - Connections

Speaker Connections

Follow these steps to connect your front (LF/RF), center (C), and surround (LS/RS) speakers. For sub- woofer or surround back connections, see page 25.

Connecting Speakers

1Route speaker wire from your speakers to the following GFR-700 terminals:

•LF - Left front

•C - Center

•RF - Right front

•LS - Left surround

•RS - Right surround

2Connect the speaker wires to the terminals using one of the following connections:

•Bare wire - Tightly wind the exposed wire strands and insert through the hole in the binding post; then tighten the binding post head in a clockwise direction.

•“U”-type spade connectors - Attach the spade connector to the binding post and hand tighten.

•“Banana” plugs - Insert the plug directly into the binding post.

3To ensure your speakers are in phase, make sure your connections maintain proper polarity (posi- tive to positive and negative to negative).

•The positive posts are red and labeled “+”.

•The negative posts are black and labeled “-”.

Bare wire

connection

“U”-type spade

connection

“Banana” plug

connection

		Right		Right				Left	Left
	Surround			Front	Center			Front	Surround
	��
��	��
	��
	��	��		��	�	��		��
	��
��	��
	���
		�������	��
�����				��������������������������
	���
				������ ����		��������������������
�	���			������	������	������	������
		��������������
��	��			�������� �������� �������	��������� ���������	��������� ���������	���������	���������
��	��			�������������
��	��	�������	��				�����	�����
					��������������
��	��						�������������������������
�����								�����������
����	�������	�������������					���������������������������

Notes:

•For subwoofer and surround back connections, see page 25.

•12~16 gauge speaker wire is recommended.

•To configure the number, size, crossover frequency, delay, and balance settings for your speakers, see pages 34-36.

24GFR-700 Owner’s Manual