Adcom GFR-700 Room 2 Advanced Configuration, Vocal Cut, Balance L / Balance R, Tone, Bass / Treble

Room 2 Advanced Configuration

The Room 2 Advanced Configuration menu contains powerful tools to customize and optimize the output of the GFR-700 to your secondary audio system.

To access the Room 2 Advanced Config menu:

1Press the Main button on the remote control.

2 Press the Setup button.

3 Use the / buttons to select ROOM 2 CONFIG, then press the Select button.

4 Use the / buttons to select ADVANCED SET- TINGS, then press the Select button.

5 Use the / buttons to choose from the follow- ing menu items:

SURROUND

Turns a “pseudo” surround effects mode on/off. Use the / buttons to select:

•On or Off

VOCAL CUT

Attenuates the normal “vocal” audio frequency range. Use the / buttons to select:

•On or Off

BALANCE L / BALANCE R

Adjusts the left and right channel balance from the Zone 2 outputs. Use the / buttons to select:

•-8 to +8 dB

TONE

Turns tone control on/off. Selecting On enables the Bass & Treble effects (see below). Use the / but- tons to select:

•On or Off

BASS / TREBLE

Adjusts the bass and treble of the audio signal from the Zone 2 outputs. Bass and Treble (Tone control) adjustments are only effective when “TONE” is On (see above). Use the / buttons to select:

•-8 to +8 dB

INITIAL POWER

Sets Room 2 to initialize in either On or Off mode whenever the main rear panel power switch is turned on. Use the / buttons to select:

•On or Off

INPUT GAIN CONFIG

Launches the Room 2 Input Gain menu, where you can set the relative gain for each possible Room 2 input source.

•Use the / buttons to select the desired input (Video 2, Video 3, Video 4, CD, AM Tuner, FM Tuner).

•Then use the / buttons to set the input gain from -8 to +6 dB.

Chapter 3 - Setup

www.adcom.com GFR-700 Owner’s Manual 39