Installing Synchrony
This section covers the connections, switch setting and software installation procedures required to use the Synchrony application with the Adder TS4 unit.
Connections for Synchrony
When using the Synchrony software utility to provide automatic system switching (according to mouse movements) it is necessary to link the Adder TS4 to the designated ‘primary’ system that will run the software utility.
Note: The remote control cannot be used in conjunction with the Adder TS4 when a Synchrony auto switching link is being used because they both use the same switching socket.
To connect the Synchrony serial link cable
1Locate the Synchrony serial link cable.
2Attach the smaller of the two cable connectors to a vacant serial port socket on the designated ‘primary’ computer system.
Vacant serial port on designated primary system
3At the other end of the cable, attach the larger connector to the socket on the end of the Adder TS4 unit.
4On the underside of the Adder TS4 unit, remember to set switch 5 to ON to enable the auto switching mode.
|
| ON |
|
|
|
| Change switch 5 |
1 | 2 |
|
|
|
|
| to ON |
|
|
|
|
|
| ||
| 3 |
|
|
|
|
| |
|
| 4 |
|
|
|
| |
|
|
| 5 |
|
|
| |
|
|
|
| 6 |
|
| |
|
|
|
|
| 7 |
| |
|
|
|
|
|
| 8 | |
|
|
|
|
|
|
|
•For application setup details, please refer to Configuration for Synchrony starting on the next page.
•For more information about how the Synchrony system works, please
refer to page 3.
