12 Document # 50075 Rev B 3/13/95
Industry Canada (IC) Compliance - "This digital apparatus does not exceed the Class
A limits for radio noise emissions from digital apparatus set out in the Radio
Interference Regulations of the Canadian Department of Communications."
IC Registration Number: 2132 6030 A
Load Number: 3
1.9.1 Normal Mode:
Normal mode is the standard mode of operation in which the UNI•COM monitors
host FACP status as well as telephone line voltage. The UNI•COM reports system
status information to UL listed Central Station Receivers. Information transmitted
includes zone/point: fire alarm, fire alarm trouble and supervisory alarm. Specific
system trouble conditions and specific UNI•COM troubles are also transmitted.
1.9.2 Serviceman Code:
The serviceman code, once entered, allows access to program, walktest, troubleshoot
and type modes. The serviceman code also enables the clear function. Refer to
following sections.
1.9.3 Program Mode:
Program mode is used to program the UNI•COM. While the UNI•COM is in the
program mode, it cannot receive host FACP status information. See Section 3.0 for
complete programming instructions.
1.9.4 Walktest Mode:
While in the walktest mode, transmission of FACP system events may be optionally
transmitted to the UCS receiver (Central Station).
1.9.5 Troubleshoot Mode:
Troubleshoot mode may be used for testing the telephone line wiring. Connection
from the UNI•COM's modular jacks, through RJ31X jacks and into the telephone
network may be easily checked. In this mode, the keypad acts similar to a telephone
touchpad.
1.9.6 Type Mode:
Type mode is used to program into the UNI•COM the system zones/points which are
non-fire alarm, i.e. supervisory type. This mode is also used to disable the alarm
report for any zone/point in the system. The feature which disables the zone/point
alarm report must be used for zones/points programmed into the host FACP as
remote silence, reset, drill or acknowledge switches.
1.9.7 Clear Function:
When the clear function is activated, it causes the UNI•COM to immediately stop
transmissions, disconnect from the telephone network, clear out any messages that
were waiting for transmission and reset.
1.9.8 Manual Test Function:
The manual test function allows a test report message to be sent to both central
stations upon activation. A Serviceman Code is not required.
1.9.9 Lamp Test Mode:
The UNI•COM 4-character display segments plus all LEDs illuminate in this mode.
1.9.10 User Code:
The user code, once entered, allows for user level testing and maintenance functions.
The user may be allowed to transmit walktest data to the UCS for the Unimode 200
system.
1.9 Modes and Special Functions