25
Document # 50075 Rev B 3/13/95
4.0 Operating Instructions
The UNI•COM has six Modes of operation; Normal, Program, Walktest,
Troubleshoot, Type and Lamp Test. Upon initial power up, the system will be in
Normal Mode. This section discusses operation of the UNI•COM in the Normal
Mode.
4.1.1 Keys: Below is a description of the function keys in Normal Mode:
Pressing the Mode Key followed by a valid 4-digit numerical code and [ENTER/
STORE] selects one of the six modes of operation.
☛To enter normal mode from any other mode press MODE then
6676 [ENTER/STORE]. 6676 spells NORM on a
Touch-Tone® phone.
If the Test Key is pressed three times in rapid succession the UNI•COM will transmit
a manual test message to both central stations.
The Clear function will cause the UNI•COM to:
• cease transmissions
• clear any active or pending transmissions
• reset and return to normal system processing
To perform the Clear function, first press the MODE key, enter a valid serviceman
code and then press the [ENTER/STORE] key. Next press the CLEAR key
followed by 2, 5, 3, 2, then press the [ENTER/STORE] key.

4.1 Normal Mode

TEST
CLEAR
MODE