To select a Bypass Group when arming the system:
1.Press , then your [access code] (if necessary).
2.Press . The next time the system is armed, the zones in this group will be bypassed.
3.To exit bypassing mode and return to the Ready state, press .
NOTE: A Bypass Group is only recalled if the system is armed/disarmed after programming the by- pass group.
NOTE: This feature is not to be used in UL Listed installations.
Trouble Conditions
When a trouble condition is detected, the Trouble () indicator will turn on, and the keypad will
beep every 10 seconds. Press the key to silence the beeps. Press to view the trouble con-
dition. The Trouble () indicator will flash. Use the keys to view troubles.
Trouble | Comments | Action | |
Condition | |||
|
| ||
|
|
| |
Service Required | Indicates Low Battery, System Trouble, System Tamper or |
| |
(Press [1] for more | RF Jam detected. | Call for service | |
information) |
|
| |
|
|
| |
| If the building and/or neighbourhood has lost electrical | Check AC | |
Loss of AC Power | power, the system will continue to operate on battery for | connection | |
| several hours. | Call for service | |
|
|
| |
Telephone Line | The system has detected that the telephone line is dis- | Call for service | |
Fault | connected. | ||
| |||
|
|
| |
Failure to | The system attempted to communicate with the moni- |
| |
toring station, but failed. This may be due to Telephone | Call for service | ||
Communicate | |||
Line Fault. |
| ||
|
| ||
|
|
| |
Sensor (or Zone) | The system is experiencing difficulties with one or more | Call for service | |
Fault | sensors on the system. Press [5] to display zone(s). | ||
| |||
|
|
| |
Sensor (or Zone) | The system has detected a tamper condition with one or | Call for service | |
Tamper | more sensors on the system. Press [6] to display zone(s). |
| |
|
|
| |
Sensor (or Zone) | If the system has been equipped with wireless sensors, |
| |
one or more has reported a low battery condition. Press [7] | Call for service | ||
Low Battery | |||
to display the zone(s). Press [7] again to display WLS keys. |
| ||
|
| ||
|
|
| |
Loss of Time & Date | If complete power was lost (AC and Battery), the time | ||
and date will need to be | Date (page 4) | ||
|
|
|
Alarm Memory
When an alarm occurs, the Alarm Memory Message will be displayed. To view which sensor(s) gener-
ated the alarm, press .
For the system keypad use the scroll keys to view the sensors in alarm memory.
Press to exit. To clear the memory, arm and disarm the system.
If an alarm sounded while armed, the system will automatically go to alarm memory when you dis- arm the system. In this instance, you should approach with caution, as the intruder may still be within the building/premises.
Door Chime (Entry/Exit Beeps)
To turn the door chime function on or off, press and hold the Chime key for 2 seconds or press
.
6