Remote Arming and Disarming
The system can be armed and/or disarmed (if programmed by the installer) using a remote control device (wireless key). When arming the system by using the Arm button on the wireless key, the system will acknowledge the command by sounding a single bell squawk and when disarming using the Dis- arm button on the wireless key the system will acknowledge the command by sounding two bell squawks . Three squawks heard when disarming with the disarm button indicates that that an alarm occurred while the system was armed. If you are unsure of the cause of the alarm, proceed with cau- tion.
Emergency Keys
Press the 
(F), 
(A) or 
(P) key for 2 seconds to generate a Fire, Auxiliary or Panic alarm. The keypad sounder will beep indicating that the alarm input has been accepted and transmission to the central station is underway. The 
(P) key may or may not sound the bell depending on Installer setup.
NOTE: The Fire keys can be disabled by the installer.
When Alarm Sounds
The system can generate 2 different alarm sounds:
•Continuous Siren = Intrusion (Burglary Alarm)
•Temporal / Pulsed Siren = Fire Alarm
Intrusion (Burglary) Alarm Continuous Siren
NOTE: If you are unsure of the source of the alarm, proceed with caution! If the alarm was accidental, enter your Access Code to silence the alarm. If the alarm system is disarmed within the programmed Abort Window (check with the installer if this option has been enabled on your system and what is the transmitter delay time programmed), no alarm transmission to the Central Station will occur. Starting at the end of the Abort Window there is a five minute Cancel window, during which a user can cancel, by entering his access code, an alarm that has been previously transmitted. A cancel signal will be transmitted to the Central Station and the alarm system will also annunciate that the cancel signal was transmitted. Call your central station to avoid a dispatch.
Fire Alarm Pulsed Siren
Follow your emergency evacuation plan immediately!
If the fire alarm was accidental (i.e. burned toast, bathroom steam, etc.), enter your Access Code to silence the alarm. Call your central station to avoid a dispatch.
2-Way Audio Operation (SCW9047 only)
If programmed by the installer, this feature allows the monitoring station to initiate a
NOTE: This feature can be initiated only by the monitoring station after an alarm has been received. The user can not initiate a
Time & Date Programming
Press 
plus your Master Access Code to enter User Functions. Use the 
scroll keys to find
the menu option then press 
to select it. Enter the time in
date (MM:DD:YY). Press 
to exit programming. If you are viewing a ‘Loss of Clock’, trouble from
within the trouble menu ( 
), press 
to directly enter Date and Time programming. See Trou-
ble Conditions on page 6),
NOTE: Your installer may have programmed your system to display the time and date while the key-
pad is idle. Press the 
key to clear the date and time display if desired.
Bypassing Zones
Use the zone bypassing feature when you need access to a protected area while the system is armed, or when a zone is temporarily out of service, but you need to arm the system. Bypassed zones will not be able to sound an alarm. Bypassing zones reduces the level of security. If you are bypassing a zone because it is not working, call a service technician immediately so that the problem can be resolved and your system returned to proper working order. Ensure that no zones are unintentionally
4
