Panasonic WJ-SX 150A manual Alarm Mode, Alarm Input Group, Camera, Serial Port

■Alarm Mode

This window configures the operation parameters when an alarm signal is input: an alarm mode, auto reset time and alarm input.

●How to Display

To display this window, click on the (Alarm Mode) but- ton in the main window (p. 80).

●Parameters

• Alarm Mode

Checking on the box of the desired alarm mode.

OFF: The system operation does not change into any other mode.

Sequence Mode: Camera images are displayed on the monitor in either the spot mode or tour sequence. When more than one alarm are input, the image associated to each alarm is displayed in the sequence mode.

Note: Click on the Dwell drop-down menu to select the dwell time.

Hold Mode: Camera images are displayed on the mon- itor in either the spot mode or tour sequence. Even more than one alarm are input, the image associat- ed to the initial alarm is continuously displayed.

Notes:

•The alarm mode is activated when alarm input signals are assigned to the same monitor through 420 ALARM EVENT or the Alarm Event (refer to pp. 67 and 68/ p. 89) window.

•While alarm is activated, you cannot operate the func- tions related to the Multiplexer board.

•Alarm Input Group

Select the alarm input to be accepted. Multiple Selection is available.

Camera

This stands for that an alarm input is accepted via the CAMERA IN connectors or the RS-485 ports.

ON: The alarm-associated sequence/spot image is dis- played on a monitor, and alarm recording will start (if a recorder is connected to the unit).

REC ONLY: Only an alarm recording will start and monitors will keep displaying the current sequence/ spot images.

Note: You cannot recover alarm-related operations from system controllers when REC ONLY is selected.

OFF: An alarm input is accepted neither via the CAM- ERA IN connectors nor the RS-485 ports.

The factory default setting is OFF.

Alarm Port

This stands for that an alarm input is accepted via the ALARM port (25-pin D-sub connector) at the rear panel.

ON: The alarm-associated sequence/spot image is dis- played on a monitor, and alarm recording will start (if a recorder is connected to the unit).

REC ONLY: Only an alarm recording will start and monitors will keep displaying the current sequence/ spot images.

Note: You cannot recover alarm-related operations from system controllers when REC ONLY is selected.

OFF: An alarm input is not accepted via the ALARM port.

The factory default setting is ON.

Serial Port

This stands for that an alarm input is accepted via the SERIAL port.

ON: The alarm-associated sequence/spot image is dis- played on a monitor, and alarm recording will start (if a recorder is connected to the unit).

REC ONLY: Only an alarm recording will start and monitors will keep displaying the current sequence/ spot images.

Note: You cannot recover alarm-related operations from system controllers when REC ONLY is selected.

OFF: An alarm input is not accepted via the SERIAL port.

The factory default setting is ON.

88