Panasonic WJ-SX 150A manual Mon1 Cam03 Pre48 Memory, Mon1 Cam03 Pre05

■Program Preset Position

1.Select the desired monitor and camera. (Refer to p. 3 Monitor Selection and p. 3 Camera Selection.)

2.To move the camera to the position to be preset, move the 3D joystick and press the lens control buttons.

3.To select the desired preset position number, press the numeric buttons. (1 to 64)

4.When you have selected a wrong number, press the CLEAR button to clear the numeric input.

5.Press the PRESET/PGM PRESET button while holding down the SHIFT button to save a preset position of the selected camera.

Mon1 Cam03 Pre48

Memory

Notes:

•If the entered position number has stored the previ- ous preset position, it will be overwritten by the new one.

•SETUP MENU and WJ-SX150A Administrator Console can configure each operator's pan/tilt con- trol. (Refer to the operating instructions of matrix switcher.)

■Call Preset Position

1.Select the desired monitor and camera. (Refer to p. 3 Monitor Selection and p. 3 Camera Selection.)

2.To select the desired preset position number, press the numeric buttons. (1 to 64)

3.When you have selected a wrong number, press the CLEAR button to clear the numeric input.

4.Press the PRESET/PGM PRESET button to move to the preset position of the selected camera on the active monitor.

Mon1 Cam03 Pre05

Notes:

•To use the above function, you must set the preset position number for the camera.

•If you press no numeric buttons or the button 0 in Step 2, the camera will move to the home position.

5