Note: The factory default setting is 150.
4.To select your registered password (up to 5 digits), press the numeric buttons, then press the CAM (SET) button.
The factory default setting is "150".
If the operator ID and password are correct, "Login OK" will blink on the LCD for about 3 seconds. Then, "Mon
User | ID | 150 |
Password | __∗ ∗ ∗ | |
Mon- |
| |
Note: If an operator ID or password error occurs, "Invalid" will blink on the LCD for about 3 seconds. Then, return to Step 3 and select your operator ID.
Invalid
Blinking
■Operation Start (Auto Login)
If the auto login is set to ON, any operators can log into the system automatically. After the controller is turned on, "AUTO" appears on the LCD for approximately 2 seconds, then "Mon
Auto login is configurable through
Mon-
Note: If you want to save the power consumption, discon- nect the DC 9 V plug from the controller, and remove the AC adapter from the AC outlet.
■Operation End (Auto Logout)
If the auto logout is set to ON and no operation takes place for a specific time, any operators can logout automatically. After the logout, "Terminal Mode No User" automatically appears on the LCD.
Terminal Mode
No User
You can activate auto logout and set up the duration until logout (configurable by minute) through
■Operation End (Logout)
This operation is skipped when the auto logout is set to ON. This function is used when an operator leaves the controller or no longer requires access to the system.
To log out of the system, press the MON LOCK/LOGOUT button while holding down the SHIFT button.
"Logout" will blink on the LCD for about 3 seconds. Then, "Terminal Mode No User" appears on the LCD.
Terminal Mode
No User
2
