2. Perform desired operations.

qMoving the clock display

Move the 3D joystick while holding down the F1 but- ton. (1) will move to the desired direction.

wMoving the Camera Title Display

Move the 3D joystick while holding down the F2 but- ton. (2) will move to the desired direction.

eMoving the Event Display

Move the 3D joystick while holding down the F3 but- ton. (3) will move to the desired direction.

rMoving the Monitor Status*

Move the 3D joystick while holding down the F4 but-

ton. (4) will move to the desired direction.

*Monitor number, controller number and monitor mode

Moving All the Items

1.Press the MENU button repeatedly until "OSD Position" appears on the LCD.

OSD Position

003

Clock Cam Event Mon

2.Hold down the SHIFT button. The LCD display will become as follows.

OSD Position

003

All

 

3.Move the 3D joystick while holding down the F1 button. (1), (2), (3), and (4) (refer to p. 11) will move to the desired position.

System Status Table

The table shows the current system status.

1.Select the desired monitor. (Refer to p. 3 Monitor Selection.)

2.Press the MENU button repeatedly until "System Status" appears on the LCD.

3.Press the F1 button.

The SYSTEM STATUS table will appear on the active monitor as shown in the figure.

 

 

SYSTEM STATUS

 

 

MON

CAM

MODE

KB

OPE

PRI

1

01

T01

K1

12345

30

2

99

SPOT

K2

2

2

3

04

ALARM

K4

4

1

4

R1

RECORDER

PC

30

1

The columns in the table indicate the states as shown in the figure.

MON:

Monitor number

CAM:

Logical camera number (01 to 99)

 

Recorder number (R0 to R4)*

 

"– –" indicates that no camera is being

 

selected.

MODE:

Lists the display mode on the

 

monitors.

SPOT:

Spot mode

Tnn:

Tour Sequence mode (nn is the

 

tour sequence number.)

CAM:

Camera Setup mode

SET:

WJ-SX150A Setup mode

ALARM:

Alarm Active mode

ACK:

Alarm ACK mode

VLD H:

Video Loss History Table

ALM H:

Alarm History Table

SYS S:

System Status Table

RECORDER: Recorder mode**

KB:

Lists the system controller name

 

(K1 to K4) or PSD.

OPE:

Lists the operator number

PRI:

Lists the priority number

* R0 to R4 shows the following.

Recorder number

Recorder

R0

Master recorder

R1

Slave 1 recorder

R2

Slave 2 recorder

R3

Slave 3 recorder

R4

Slave 4 recorder

**When this parameter is selected, a recorder number is displayed in the CAM area.

4.To close the SYSTEM STATUS table, press the F2 but- ton.

5.To exit the mode, press the MON (ESC) button.

12

Page 184
Image 184
Panasonic WJ-SX 150A manual Moving the clock display, Moving the Camera Title Display, Moving the Event Display