Panasonic WJ-SX 150A manual To Control a Recorder and Cameras via the Network

●To Control a Recorder and Cameras via the Network

The following is the description of the connection between a recorder and this unit to control the recorder and cameras via the network.

1.Set the unit address of the recorder to 5 or larger. (Refer to the recorder’s operating instructions.)

2.Set the [Camera control] setting to “PSD” for all cameras in SETUP MENU of the recorder.

3.Connect the unit’s CAM OUT 1 to 16 connectors to the recorder’s VIDEO IN 1 to 16 connectors with a coaxial cable.

4.Connect the unit’s EXT IN connector to the recorder’s MULTISCREEN OUT connector with a coaxial cable.

5.Connect the unit’s DATA HDR and DATA4 connectors to the recorder’s DATA ports with modular cables.

6.Select the recorder’s new unit address, which is set in Step 1, in 600 RECORDER of SETUP MENU or the Recorder window of WJ-SX150A Administrator Console. (Refer to this unit’s operating instructions.)

System controller (Terminal Mode)

																	Monitor
										EXT IN						MONITOR OUT
													EXT IN		3	1	SIGNAL GND
				ALARM				SERIAL					(PLAY IN)
					DATA HDR DATA 4		DATA 3		DATA 1	RS485(CAMERA)			CAMERA
								DATA 2			LINE		SW IN
				TERM						2	SELECT	4
				OFF	ON
													EXT OUT		4	2	POWER
						PS•DATA		RS485(CAMERA)					(REC OUT)		MONITOR OUT
16	15	14	13	12	11	10	9	8	7	6		5	4	3	2	1
IN
																	AC IN
OUT
16	15	14	13	12	11	10	9	8	7	6		5	4	3	2	1
							CAMERA
			DATA HDR			DATA 4
						(PS·Data)											Matrix Switcher

MONITOR OUT x

DATA

3	1		1
				SERIAL	ALARM
		CASCADE
4	2	OUT	2
AUDIO IN	AUDIO OUT		MONITOR OUT CASCADE IN	MONITOR (VGA)	ALARM/CONTOROL

			SIGNAL GND
	MODE		COPY 1
	2	1
			POWER
DATA	RS485(CAMERA)		10/100BASE-T EXT STORAGE

16	15	14	13	12	11	10	9	8	7	6	5	4	3	2	1
IN
															AC IN
OUT
16	15	14	13	12	11	10	9	8	7	6	5	4	3	2	1
							VIDEO

Recorder*

HUB/Router

LAN**

*Set the recorder’s unit address to 5 or larger.

**LAN: Local Area Network

Notes:

•Select the PS·Data protocol for the DATA 4 setting. (Refer to this unit’s operating instructions.)

•If the recorder’s unit address, set in Step 1, and the recorder setting, set in Step 6, are different, the recorder will not be operable.

•In these connections, you cannot use a PS·Data system controller.

•From system controllers connected to the unit, you cannot control the monitor connected to the MONITOR OUT 1 connec- tor of recorder.

38