Problem | Check item | Remedy |
The alarm mode is not activated.
The alarm mode is set to OFF. | Set the alarm mode to SEQUENCE or |
| HOLD in SETUP MENU or |
| Administrator Console. |
| SETUP MENU: Refer to p. 67. |
| Administrator Console: Refer to p. 88. |
|
|
The port for an alarm input is set to | Set the alarm port to ON in SETUP |
OFF. | MENU or |
| Console. |
| SETUP MENU: Refer to pp. 68 to 69 |
| Administrator Console: Refer to p. 88. |
|
|
When "ALM SUSPENDED" is displayed | Press the ACK/SUSPEND button while |
on the monitor, the alarm is suspended. | holding down the SHIFT button to can- |
| cel the alarm suspension. |
SETUP MENU may be open.
Press the SETUP button while holding down the SHIFT button to close SETUP MENU.
ACK or RESET is not activated.
You may not have selected the alarm- | Select the monitor again. (Refer to pp. |
related monitor. | 106 or 125.) |
|
|
The system controller is not authorized | Confirm the Monitor Selection window in |
to select the monitor. | |
| reconfigure the setting if necessary. |
| (Refer to p. 92.) |
|
|
You are not authorized to reset an | Confirm the Level Table window in WJ- |
alarm. | SX150A Administrator Console and |
| reconfigure the setting if necessary. |
| (Refer to p. 91.) |
|
|
While the PROHIBITED indicator is | Open the Monitor Selection window |
lighting on the system controller, you | (refer to p. 92) and reconfigure the set- |
are prohibited to control the monitor. | ting if necessary. |
Timer event is not activated.
A | Select another monitor. |
selected the |
|
SETUP MENU does not open.
When the PROHIBITED indicator is light- ing on the system controller, you are pro- hibited to open SETUP MENU.
Open the Level Table window (refer to p. 91) and reconfigure the setting.
The system does not enter the recorder mode.
The recorder connection may be wrong.
Connect the recommended recorder to the unit.
The connected recorder may not con- form to the unit.
Confirm the recorder connection (refer to pp. 40 to 47.)
You are not authorized to operate the recorder.
Open the Level Table window (refer to p. 91) and reconfigure the setting.
“NOT ASSIGN” is displayed beside the | When you select the LCN (logical cam- | Select an assigned logical camera num- |
camera number on the monitor. | era number) not assigned in the system, | ber. (Refer to p. 107.) |
| “NOT ASSIGN” will appear. |
|
|
|
|
“Initializing…” is displayed on monitors. | If connections or settings are wrong, this | Confirm the connections (refer to pp. 33 |
| message, SLAVE n*, and the firmware | to 55) and settings (refer to pp. 57 to |
| version will be displayed after you turn | 102). |
| on a Slave recorder. |
|
| *n is a unit number. |
|
|
|
|
(For | “Error” or “TIME OUT” may be displayed | The |
cannot search for records even when car- | after pressing the PLAY button in the | able. Use Record List or Thumbnail |
rying out the Search Playback procedure. | Display to search for records. | |
|
|
|
Recording or playback with the recorder | Camera number settings are wrong. | Conform the LCN (logical camera num- |
is not correctly carried out. |
| ber) settings of the unit and camera |
|
| number settings of the recorder. |
|
|
|
