Total Access 1224 Quad T1 IMA 24-Port DSLAM Installation and Maintenance Practice
3-20 61179621L1-5C
10. From the T1 Provisioning menu, configure the Type, Framing, Line Code, and Line Build Out
setting to match the settings of the T1DS1s provided. Press N to access the next T1/DS1
to configure and continue this process until all the T1/DS1s are properly configured.
11. From the T1 Provisioning menu, press ESC to return to the T1 Main Menu.
12. From the T1 Main Menu, select T1 Status, and press ENTER.
13. From the T1 Status menu, confirm that the T1/DS1s do not have active alarms.
NOTE
If the T1/DS1s have active alarms, this is an indication of a net-
work feed issue.
14. From the T1 Status menu, press ESC until the Network Port menu displays.
15. From the Network Port menu, select IMA and press ENTER.
16. From the IMA Main Menu, select Provisioning, and press ENTER.
17. From the IMA Provisioning menu, select IMA Facility, and press ENTER.
18. From the IMA Facility Provisioning for # 1 menu, select Facility Operation Mode, and press
ENTER.
19. From the Operation Mode for Facility for # 1 menu, provision the facilities as appropriate.
For more information, refer to “Operation Mode for Facility Menu” on page 5-110.
The default settings assign the four facilities to the IMA Group.
20. From the Operation Mode for Facility for # 1 menu, press ESC until the IMA Provisioning
menu displays.
21. From the IMA Provisioning menu, select IMA Group, and press ENTER.
22. From the IMA Group Provisioning menu, select Group Operation Mode, and press ENTER.
23. From the Group Operation Mode menu, select In Service, and press ENTER.
24. Press ESC until the Main Menu displays.
25. From the Main Menu, select System Management, and press ENTER.
26. From the System Management menu, select IP Address, and press ENTER.
27. From the Mode Selection and Current IP Settings menu, verify that the Mode is set to
Static.
28. From the Mode Selection and Current IP Settings menu, select Configure IP, and press
ENTER.
29. From the Status IP Settings - for IP over ATM menu, configure the following fields:
• IP Address
•Subnet Mask
•VPI/VCI
•Default Gateway