AEG 3009VNM-M H - Gas Cooktop Functions, Automatic start-up with valves, Using the burners

H - Gas Cooktop Functions

Automatic start-up with valves

Turn the corresponding knob anticlockwise up to the maximum position and press the knob. Once the burner has been started up, keep the knob pressed for about 6 seconds.

Using the burners

In order to obtain the maximum yield without wasting gas, it is important that the diameter of the pot is suitable for the burner potential (see the following table and fig.1). This is to avoid the flame extremities being larger than the base of the pot. All of the operating positions must be chosen between the maximum and the minimum ones, never between the minimum position and the closing point.

The gas supply can be interrupted by turning the knob clockwise up to the closing position.

NOTE:

If there is no power supply, it is possible to light the burners with matches, setting the knob to the startup

point (large flame, fig. 1).

	POWER (MJ/h)	Ø of pots
BURNERS	POWER (Btu/h)
Auxiliary	3.2	10 - 14 cm
	3000
Semi-rapid	6.3	16 - 18 cm
	6000
Rapid	11.6	20 - 22 cm
	11000
Wok	17.9
	17000	24 - 26 cm

NOTE:

When the equipment is switched off, always check that the knobs are in the closing position.

If the flame should blow out accidentally, the safety valve will automatically stop the gas supply, after a few seconds. To restore operation, set the knob to the lighting point and press. While cooking with fat or oil, pay the utmost attention as these substances can catch fire when overheated.

WARNING:

-Do not use sprays near the appliance in operation.

-Do not place unstable or deformed pots on the burner, so as to prevent them from overturning or overflowing.

-Always turn gas off if moving a pot away from the appliance.

17