AEG 3009VNM-M, 3009VNMM user manual A - Installation instructions check and warnings, Ventilation

A - Installation instructions check and warnings

IMPORTANT:

Please ensure that the cavity, venting and wiring is as specified in the relevant section J of this manual.

A licensed electrician with relevant qualifications must perform electrical work when installing or servicing the appliance. The supply cable and fuse rating must be suitable for the appliance. You must never repair or replace any part of the appliance unless specifically recommended in the operation manual.

Ventilation opening must not be covered or obstructed in any way.

VENTILATION

The room containing this cooker should have an air supply in accordance with local regulations.

-All rooms require an open window, or equivalent and some rooms will require a permanent vent as well.

-For room areas up to 5 m2 an air vent of 100 cm2 is required.

-For room areas between 5 m2 and 100 cm2 an air vent of 50 cm2 is required.

-If the room is greater than 5 m2 and has a door that opens directly to the outside, then no air vent is required.

-If there are other fuel burning appliances in the same room local regulations should be consulted to determine the air vent requirements.

DISCHARGE OF FUEL GASES

Cooking appliances must always discharge the flue gases into special hoods (fig.1-C), which must be connected to chimneys, flue pipes or have direct access to the outside. If it is not possible to connect a hood, an electric fan can be fitted to a window or

awall (fig.1-E), which must be turned on when the cooker is on, as long as ventilation standards are strictly adhered to.

Fig.1

3