AEG 70730 manual RINCAGE+ flashes Water

Instructions for use

Problem	Possible Cause	Remedy
No water runs in.	Water valve is closed.	Open the water valve.
		Close the water valve.
Fault code E10
appears. The indicator	Filter in screw connection of	Unscrew the hose from the
		water valve, remove the filter
RINSE+ (SPOELEN+,	the intake hose is blocked.
		and clean it under running
RINCAGE+) flashes.
		water.
	The height-adjustable screw	Adjust in accordance with
		the installation and connec-
	feet are not correctly set.
		tion instructions.
	There is not much washing in	This does not impair the
	the drum (e. g. only one
The washing machine		function.
	dressing gown).
vibrates during opera-
tion or it is on an une-	The water could not be com-	Check the laying of the
ven surface.		drainage hose and eliminate
	pletely pumped off before	the bend if necessary, or
	spinning because the drain-
		clean the solution pump and,
	age hose is bent
		if required, remove foreign
	or
		bodies from the pump hous-
	the solution pump is blocked.
		ing.
The washing solution	Too much detergent was	Meter the detergent exactly
of the main wash		in accordance with the
	probably used.
froths up a lot.		manufacturer's information.
	The screw connection on the	Tighten the intake hose
	intake hose is leaky.	screw connection.
	The drainage hose is leaky.	Check the drainage hose and
		replace it if necessary.
	The washing solution pump	Close cover correctly.
	cover is not correctly closed.
Water runs out under	Washing stuck in the filling	Stop the program, remove
the washing machine.		washing from the filling
	door.
		door, start a new program.
		Shut the emergency drain
	The emergency drain hose is	hose off properly (see section
		"Performing an Emergency
	not properly shut off or it is
		Drain"). Call your after-sales
	not water-tight.
		service if the emergency
		drain hose is not water-tight.

34