Positioning, Levelling | AEG L 12510 VI, L 14510 VI instruction

Installation

Set the machine

upright and remove the two remaining bolts from the back.

Pull out the three

plastic spacers from

the holes into which the bolts were fit- ted.

Plug the open holes with the plugs which you will find in the plastic bag containing the instruction booklet.

You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc.

•Before placing it on small tiles, apply a rubber coating.

•Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine.

•If it is impossible to avoid positioning the machine next to a gas cooker or coal-burning stove, an insulating panel (85x57 cm) covered with alumini- um foil on the side facing the cooker or stove, must be inserted between the two appliances;

•The machine must not be installed in rooms where the temperature can drop below 0°C.

•The water inlet hose and the drain hose must not be kinked.

•Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event of a breakdown.

Levelling

Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or sim- ilar materials under the machine to compen- sate for any unevenness in the floor.

46

Image 46

AEG L 12510 VI, L 14510 VI manual Positioning, Levelling

Contents

Lavamat L 12510 VI Lavamat L 14510 Dear customer Contents Technical data Service & Spare Parts Guarantee Conditions Building-in General safety Safety instructionsInstallation Child safety During use Packaging materials DisposalMachine Tips for environmental protection Main features of your washing machine Delay Start delayed start Description of the appliance Front view Control panel Programme selector dial Mains-on light Delay Start buttonON/OFF button START/PAUSE button Programme Option buttons Spin Speed Prewash Display Cancelling a programmeProgramme progress display Altering an option/programme which is running Opening the door after the programme has started Detergent dispenser drawer Before the first wash Preparing the wash cycle Sorting out and preparing the laundry Cotton Weight of laundryTypes of fabric and care labels Synthetics Easy-cares Delicates Detergents and additives Which detergent? Which form? Traditional Powders Load the laundry How to washSwitching the machine on Add detergent and additive Selection of the desired wash programme Selection of the Delay Start optionSelection of the desired option Starting the programme At the end of the programme 60E Programme chartWash programmes 40E Special programmes Max Consumption After each wash Cleaning and maintenancePeriodical cleaning Exterior Door seal Drain filter Water inlet filter Frost precautionsEmergency emptying out Troubleshooting Something not working? Problem Noisy Feet have not been Problem Possible cause Foam is still visible even after the last rinse Unsatisfactory washing resultsIf grey stains remain on the laundry White residue is left on the laundry Technical data This appliance complies with the following EC directives 08705 929 Service & Spare PartsService & Spare Parts Help us to help you Customer care Guarantee Conditions Guarantee does not cover commercial use European Guarantee Instructions for installation and electrical con- nection Safety instructions for the installer Front view and side view Rear view Installation Unpacking Positioning Levelling Do not connect to a hot water supply Water inlet cold water connection onlyWater drainage Into a drainage standpipe Push the drain hose Interest of the environment Electrical connections Permanent connection Building-in Preparation and assembly of the doorDoor Mounting the door HingesCounter-magnet Drill four fixing holes see Fig. G Building-inInstallation From the Electrolux Group. The world’s No choice