Recommendations regarding the construction and fitting of a base when the installation requires an integrated appliance to be raised
Where the appliance has been raised by mounting onto a wooden base pro- vided by the installer. The material used to construct the base should have a non slip surface, be water repellent and if possible be one solid piece.
If it is not possible to use one solid piece, due to the additional height required, ensure that any additional strips of timber are glued and screwed to the under- side of the base (see Fig. F).
5 mm Hardwood strip
40mm 
100 mm
Front
Fview
Additional pieces of 
timber should run
from front to back
Drill four fixing holes see Fig. G
Position the base into the recess with its front edge as far forward as the adjoining plinth line will allow. The reason for placing the base in this position is to allow a small strip of bead- ing to be fitted in front of the appliance feet.
95 mm |
Front edge 50 mm
Top
Gview
490mm
Fix the base firmly to the floor using four appropriate countersunk screws
(see Fig. H).
Hardwood strip 5 mm x 25 mm
5 X 25 X 605
490
H
53
