PROTECT C. with 2 battery expansions

Fig.: PROTECT C. 1000 and two C. 1000BP

1.Check the correct fit of the UPS and the battery unit (the casings e.g. have to have the same dimension).

2.Now connect the corresponding battery connectors using the supplied battery connection cables as shown in the figure above. When connecting, make sure that you push the plug quickly and firmly in the battery connectors.

5.2.1Electrical Start-Up

Verify that UPS voltage of your country corresponds to your equipment voltage. The default setting is set to 230 V. Output voltage on the UPS system can be adjusted with the software “CompuWatch” in steps of 220 Vac, 230 Vac and240 Vac.

Turn on the PROTECT C. to the mains

1.Now connect the input of the UPS to the mains connection cable provided and plug the mains connector into a suitable shockproof socket. Avoid using extension cables and / or adapters. In particular in the case of high-capacity types, ensure that the fusing in your sub-distribution is adequately dimensioned: The 3kVA system for example requires its own connection with a 16 A fuse. No other loads should be connected to this circuit!

2.Activate the mains input circuit breaker. If necessary switch it to “ON”.

27