Aga Ranges DESN 512387 A owner manual I. To Remove Electrodes Lhr, Cf, Cr, Rhr, Rhf Burners

I.TO REMOVE ELECTRODES (LHR, CF, CR, RHR, RHF BURNERS)

1.Isolate from electric supply.

2.Proceed as ‘TO REMOVE THE HOTPLATE’.

3.Proceed as ‘TO REMOVE SPARK GENERATOR’ disconnect the appropriate electrode lead.

4.Withdraw clip securing electrode to burner and withdraw lead and electrode (See Fig. 29).

5.Re-assemble in reverse order.

Fig. 29 DESN 513541

Fig. 29A DESN 513713

J.TO REMOVE ELECTRODES (LHF BURNER)

1.Isolate from electrical supply.

2.Proceed as ‘TO REMOVE HOTPLATE’.

3.Proceed as ‘TO REMOVE SPARK GENERATOR’.

4.Disconnect the left hand burner pipe (13mm) and the inner burner pipe (13mm) using the special spanner.

5.Remove the burner and burner fixing plate, by unscrewing the (4) screws holding the burner mounting plate in place.

6.Turn burner over and remove electrode fixing clip. Withdraw electrode through top of burner checking on route of lead.

7.Re-assemble in reverse order, re-routing lead along the same path.

55