39
Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
The neutral or ground wire of the power cord must
be connected to the neutral terminal located in
the center of the connector block. The power leads
must be connected to the outside terminals.
Make sure the connections are tight. Now tighten
the stain relief device to clamp the power cord.
Refi t the electrical connection cover
3-Wire Conduit Installation
Disconnect the supplied power cord from the
terminal block and ground post. Keep the terminal
block parts; you will need them. Remove the strain
relief clamp from the power cord and remove
the power cord and strain relief clamp from the
mounting bracket.
The range is shipped with reducer plates to give a 1
1/8’’ diameter opening for conduit connection. Find
the reducer plates in the miscellaneous parts pack
and fi t them to the mounting bracket.
Fit a squeeze connector (not supplied with the
range), to your conduit. Insert the conduit through
the reducer plates on the mounting bracket. Allow
enough slack to easily attach the wires to the
terminal block.
NOTE: Do not install the conduit without a squeeze
connector.
A Ground strap is supplied
in the miscellaneous parts
pack. ground strap. (grey)
Fit the Ground strap to the ground and center
terminal of the connector block - see the fi gure.