Aga Ranges U110054 - 03A manual Cleaning Table Table, Part Finish Recommended Cleaning method

Fig.6-14

Fig.6-15

ArtNo.302-0005a -

6BC Stopping the oven 1a

Part	Finish	Recommended
		cleaning method
Burner grates &	Porcelain enamel	Mildly abrasive cleaner such as
top of burner		Bon Ami ® or Soft Scrub®.
heads		Dishwasher.
Burner base	Aluminum	As above.
Maintop top	Stainless steel	Hot soapy water, non-abrasive
		cleaner, soft cloth.
Sides, toe-kick	Painted enamel	Hot soapy water and soft cloth.
Control panel	Painted enamel	Non-abrasive cleaner, soft cloth.
	or stainless steel
Oven interior	Porcelain enamel	Branded oven cleaner suitable for
		enamel surfaces. Take care not to
		damage the oven door seals.
Door handles	Chrome plated	Non-abrasive cleaner, hot soapy
	aluminum	water, soft cloth.
Oven racks &	Chrome	Dishwasher. Hot soapy water and
supports		scouring pad.
Door inner	Glass	Hot soapy water and soft cloth.
		Mildly abrasive cleaner with a soft
		cloth.
Outer door	Painted enamel	Multi-surface cleaner, soft cloth.
and drawer	or stainless steel

Table 6-2

To cancel the self cleaning cycle

To cancel the self-clean function, hold down the [D] button and then press the [–] button to set the timer back to ( 0.00). The heating part of the cycle will end and the cooling part of the cycle will start. When the oven temperature has fallen sufficiently the interlock neon will go out and the door will unlock.

When the door has unlocked turn the oven function control back to OFF.

WARNING!

DO NOT attempt to stop the self-clean cycle by turning the oven function control to OFF. While this will stop the heating part of the cleaning cycle it will also stop the ventilation fans from running and cause the oven thermal cut-out to trip.

To start the self cleaning cycle automatically

By using the timer, the self-clean cycle can be programmed to turn on and off automatically.

Note: You cannot set the start time directly – this is set automatically by setting the ‘Cleaning period’ and the ‘Stop time’.

Set the oven function control to self-clean (Fig.6-10). Press the [D] button once to set the default cleaning time (Fig.6-12). To adjust the cleaning cycle duration, hold down the [D] button and press either the [–] or [+] buttons and set the time as required.

Now press the [E] button once to bring up the minimum ‘Stop time’ (Fig.6-14)on the display. Press and hold the [E] button and then press the [+] button until the required ‘Stop time’ shows (Fig.6-15). Release the buttons.

The self-clean cycle will now start automatically.

To cancel the automatic self cleaning cycle

To return to manual operation the ‘Cleaning period’ must be cancelled. Press and hold the [E] button and then press the [–] button until the timer display reads ( 0.00).

Cleaning Table (Table 6-2)

Cleaners listed are available from supermarkets or electrical retailers as stated. For enamelled surfaces use a cleaner that is approved for use on vitreous enamel.

Regular cleaning is recommended. For easier cleaning, wipe up any spillages immediately.

22