Aga Ranges U110054 - 03A manual Before using the self-clean function, Self-Clean Operation

To remove and refit the telescopic rack and runners

Slide the rack out on the runners. While holding one of the runners securely, carefully lift the rear of the rack upwards: the rack will spring clear of the central restraining tab. Repeat for the opposite side of the rack.

Note: To aid the removal of the shelf you can insert a suitable flat tool through the opening in the side of the runners and lever the rack clear (Fig.6-8).

Tilt the front of the rack downwards and then lift clear of the runners (Fig.6-9).

Refit in the reverse order, making sure to push the rack down onto the runner arms.

To remove and refit the ladder rack supports

Lift the ladder support hooks out of the two locating holes in the oven side (or divider) before lifting the support clear of the bottom ladder restraint.

Refit by inserting the bottom of the ladder into the restraint before fitting the hooks through the locating holes.

Before using the self-clean function

Pre-clean any areas that are not reached by the self-clean cycle, such as the outer edges of the oven door. Wipe up any excess fat or liquids.

Before operating the self clean cycle, use hot water and detergent or a paste of water and baking soda to remove any difficult spots. Rinse off all residue with vinegar water. This will prevent this soil from being baked on by the high heat of the self-cleaning cycle.

Self-Clean Operation

Set the oven function control to self-clean (Fig.6-10). The timer display will now show a ‘P’ (Fig.6-11).

Press the [D] button once (Fig.6-12)to set the default cleaning time (3 hours). To adjust the cleaning cycle duration, hold down the [D] button and press either the [–] or [+] buttons and set the time as required; see Table 6-1.

Note that the maximum time for the self-cleaning operation is 4 hours.

The cooling fan will switch to high speed and as soon as a certain temperature is reached the oven door will lock as indicated by the illuminated interlock neon (Fig.6-13).

Note: Because of the high temperatures generated during the self-cleaning, the door will remain locked for some time after the cleaning cycle has finished. When the oven temperature has fallen sufficiently the interlock neon will go out and the door will unlock.

WARNING! The oven will still be hot!

When the door has unlocked turn the oven function control back to OFF.

When the door has unlocked and the oven has cooled, use a damp cloth the clean the debris and ash.

Fig.6-10

OFF

Fig.6-11

ArtNo.302-0013 - 6BC Self clean 1

Fig.6-12

ArtNo.302-0014 - 6BC Self clean 2

Fig.6-13

ArtNo.272-0008

Prof+ pyroOFFUS - MF oven -

Self clean light on

Hours		Soiling
2 hours		Normal clean
3 hours		Heavy soiling
4 hours		Very heavy soiling
	Table 6-1

21