Aga Ranges U110054 - 03A Anti-Tip Device, Wall Attachment, Side Panel Extension kit, Kit Contents

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

Anti-Tip Device		Fig.7-10
 WARNING!	2
		3
	1
The range MUST be secured by the anti-tip bracket
supplied. Unless properly installed, the range could		3
be tipped by leaning on the door and injury might
result from spilled hot liquids or from the range
itself.

Note: The range must be set to the correct height and leveled before the anti-tip bracket is installed.

Kit Contents:
1.	Anti-tip bracket base	1
2.	Anti-tip bracket extension	1
3.	M5 screw	2

Assemble the anti-tip bracket base and anti-tip bracket extension as shown using M5 screws (Fig.7-10).

Dimension ‘A’ should be set to give a clearance of about ¼”

(0.6 cm) above the rear channel of the range base (Fig.7-11).

The assembled bracket should be firmly secured to the floor to give a minimum engagement of 2’’ (5 cm) in the rear channel of the range base. If the range is mounted on a protective sheet make sure the bracket base is firmly attached to the floor not just the sheet (Fig.7-12).

Wall Attachment

When floor attachment is impractical you may attach the anti-tip bracket base securely to a solid wall or wall stud (Fig.7-13).

For both floor and wall attachment it is essential to use the appropriate fixing screws and to ensure that the anti-tip bracket is firmly attached.

Side Panel Extension kit

Two side extension panels are supplied with the range. These can be installed where the side of the range is exposed, preferably during the installation of the appliance.

Procedure

1.Loosen the 2 screws in the rear edge of the range side panel.

2.Using the cut-outs, locate the side extension onto the protruding screw heads (Fig.7-14).

3.Push the side extension up to so that the tab in the bottom of the flue extension fits into the slot at the top (Fig.7-15).

4.Hold the side extension in place and tighten the screws to secure.

ArtNo.280-0032 - Assembling the Anti-tip bracket

Range in normal	Fig.7-11
working position	ArtNo.011-0020 - Positioning anti-tip bracket
	A
	Floor
Fig.7-12	Fig.7-13

No.280-0033 - Anti-Tip fixed to floor ArtNo.280-0034 - Anti-Tip mounted to wall

Fig.7-14

Fig.7-15

29