Agilent Technologies 60502B manual TRANFREQ value, shift, DCYCLE value, TRANDCYC value

Function

Transient Operation Set Frequency

Set Duty Cycle

*Set Pulse Width

Trigger Operation

*Set Trigger Period

Current Protection *Set Current Level *Set Delay Time

Table 60502-2. Programming Ranges (continued)

Front Panel	Front Panel	HPSL Command
Key	Display	(Short Form)
	FREQ value	"TRAN:FREQ value"
(shift)	DCYCLE value	"TRAN:DCYC value"

"TRAN:TWID value"

"TRIG:TIM value"

"CURR:PROT value" "CURR:PROT:DEL value"

*Can only be programmed remotely via the GPIB.

Range of Values

0.25 Hz to 10 kHz

3-97% (0.25 Hz-1 kHz)

6-94% (1 kHz-10 kHz)

0.00005 to 4 s

0.000008 to 4 s

0 to 61.2 A

0 to 60 s

	Table 60502-3. Factory Default Settings
Function	Settings	Function	Setting
CURR level	0 A	Mode (CC, CR, CV)	CC
CURR transient level	0 A	Input (on/off)	on
*CURR slew rate	1 A/μs	Short (on/off)	off
CURR range	60 A
		Transient operation (on/off)	off
*CURR protection (on/off)	off	***TRAN mode	continuous
**CURR protection level	61.2 A	(continuous, pulse, toggle)
**CURR protection delay	15 s	TRAN frequency	1 kHz
		TRAN duty cycle	50%
RES level	1 kΩ	**TRAN pulse width	0.5 ms
RES transient level	1 kΩ
RES range	1 kΩ	**TRIG source	hold
		(bus, external, hold, timer, line)
VOLT level	60 V	**TRIG period	0.001 s
VOLT transient level	60 V	**PORT0 output (on/off)	off (logic 0)
VOLT slew rate	5 V/μs	**CAL mode (on/off)	off

The *RST command resets the CURR slew rate to 5 A/μs, not to the factory default.

**Can only be programmed remotely via the GPIB.

***Continuous transient mode is the only mode available at the front panel. Pulsed, toggled, and continuous modes can all be programmed remotely via the GPIB.

7