ENGLISH
Preventing accidents is the responsibility of every equipment operator. The following general safety precautions must be fully understood and followed by every operator.
1.Do not at any time carry passengers in this cart. It is designed for carrying materials only and not intended to carry passengers.
2.Be careful on any grade (hill) and stay off of steep grades.
3.Use caution when loading cart to avoid tipping.
4.Avoid large holes and ditches when transporting loads.
Your Farm/Yard Cart carton contains a hardware package with parts as shown in the chart below and in figure 1.
Contents of Hardware Pack: (See figure 1)
REF. | QTY. | DESCRIPTION |
|
|
|
A | 6 | Screws, M6 X 50 |
B | 2 | Screws, M6 X 40 |
C | 8 | Screws, M6 X 30 |
D | 21 | Screws, M6 X 25 |
E | 4 | Cotter Pins |
F | 37 | Hex Nuts, M6 |
G | 33 | Flat Washer, Φ6 |
H | 4 | Lock Washers, Φ6 |
I | 4 | Large Flat Washers |
|
|
|
HARDWARE REFERENCE CHART
A 
B 
C 
D E
M6X25
M6X30
M6X40 M6X50
F G H
I
TOOLS REQUIRED
(1)Screw Driver
(1)Pliers
(1)10 mm Wrench
When assembling your cart, place the heads of all screws to the inside and hex nuts with flat washers to the outside.
1.Lay the front angle assembly down (flat) on floor and stand the bottom panel in position as shown in figure
2.
NOTE
Thebottompanelhasonegalvanizededge; this is the rear. The front edge has three holes. See figure 2.
2.Line up three holes in bottom panel with holes in front angle assembly. Start three M6 x 25 screws through bottom panel, then through angle. Secure screws with Ф6 flat washers and M6 hex nuts. Tighten securely. See figure 2.
BOTTOM
PANEL
M6 |
|
|
| |
HEX |
|
|
| |
NUT |
|
|
| |
Ф6 |
| THREE |
| |
FLAT |
| FRONT | ||
WASHER | M6X25 | HOLES | ||
ANGLE | ||||
| SCREW |
| ASSEMBLY |
FIGURE 1 | FIGURE 2 |