Agri-Fab 45-01773 5

ENGLISH

16.Turn the cart upside down. Place the handle tube on the bottom of the cart as shown in figure 10. Place the four tube clamps over the handle tube, with the longer leg of each tube clamp to the outside.Secure the four tube clamps over the handle tube using eight M6X25 screws, eight flat washers and eight hex nuts.Make only finger tight until all eight screws are in place and then tighten securely. See figure 10.

NOTE

The length of the handle tube can be adjusted by sliding the tube in or out before tightening the four clamps. see figure 10.

17.	Insert a M6X25 screw through the hole at the rear of
	each side panel and the hole at the rear of each side
	angle. Secure with M6 flat washers and M6 hex nuts,
	making only finger tight at this time. See figure 11.
18.	Place the tube caps on the ends of the “W” shaped leg
	tube. See figure 11.
19.	With the cart still upside down, assemble the leg tube
	to the bottom of the cart. Line up the two holes in the
	center of the leg tube with the holes in the bottom of
	the cart. Secure the leg tube to the bottom of the cart
	with two M6X50 screws, M6 flat washers and M6 hex
	nuts. Make only finger tight at this time. See figure 11.
20.	Attach the leg tube to the side panels with four M6 x50
	screws, M6 flat washers and M6 hex nuts. Make only
	finger tight at this time. See figure 11.
21.	Fasten the support straps to the leg tube with two M6X40
	screws, M6 flat washers and M6 hex nuts. See figure
	11.