
ENGLISH
3.Turn the front angle assembly and bottom panel upside down as shown in figure 3.
4.Lay the two side angles on the bottom panel so that the two holes for the axle clamps are closer to the front angle assembly. See figure 3.
5.Secure both axle clamps to the side angles and the bottom panel using four M6 x 30 screws, lock washers and hex nuts. Make only finger tight until axle is assembled. See figure 3.
| M6 | Ф6 | FRONT | |
| HEX | ANGLE | ||
AXLE | LOCK | |||
NUT | ASS'Y | |||
WASHER | ||||
CLAMP |
|
| ||
|
|
|
M6X30
SIDE SCREW
ANGLE
BOTTOM
PANEL
SIDE
ANGLE
FIGURE 3
7.Stand the cart on end with the front angle assembly down on the floor. Temporarily place four large flat washers
(axle washers) on the inside of front angle assembly.
See figure 5.
NOTE
These washers act as shims and are just for assembly purposes. You will remove them later to use on axle.
BOTTOM
PANEL
LARGE
FLAT
WASHER
| FRONT |
FRONT | PANEL |
| |
ANGLE |
|
ASS'Y |
|
FIGURE 5
6.Secure both side angle assemblies to the bottom panel using four M6 x 25 screws, flat washers and hex nuts. Make only finger tight until all four screws are in place, then tighten securely. See figure 4.
M6
Ф6HEX
FLATNUT WASHER
M6X25
SCREW
FIGURE 4
8.Lay the front panel down onto the front angle assembly, on top of the four large washers. See figure 6.
FRONT
ANGLE
ASS'Y
LARGE
FLAT
FRONT WASHER
PANEL
FIGURE 6