ENGLISH
9.Position a side panel againist a side angle, resting it down on top of the front panel. Place a support strap on the outside of the side angle and start a M6X30 screw through the second hole in the side panel, the side angle and the support strap. Secure with a flat washer and hex nut. Make only finger tight at this time. See figure 7.
10.Start a M6X30 screw through the top hole in the side panel, the front angle assembly and the support strap.
Secure with a flat washer and hex nut.Make only finger tight at this time. See figure 7.
11.Repeat steps 9 and 10 for the other side panel.
SECOND | M6X30 | |
HOLE | ||
SCREW | ||
|
SIDE
PANEL
M6X30
SCREW
|
| TOP |
| Ф6 | HOLE |
|
| |
M6 | FLAT |
|
WASHER |
| |
HEX |
|
NUT
FRONT
FRONT PANEL
SUPPORT ANGLE
STRAP ASS'Y
FIGURE 7
12.Start one M6X25 screw through the bottom hole in the side panel and the front angle assembly. Start another M6X25 screw through the front hole in the side panel and the side angle. Secure with two flat washers and two hex nuts, making only finger tight at this time.
See figure 8.
13.Repeat step 12 for the other side panel.
14.Tighten all nuts and screws securely at this time, except for nuts and screws in axle clamps. See figure 8.
SIDE
PANEL
FRONT
HOLE 
M6X25
SCREW
BOTTOM 
HOLE
M6 | Ф6 | FRONT | FRONT |
PANEL | |||
HEX | FLAT | ANGLE |
|
NUT | WASHER | ASS'Y |
|
FIGURE 8
15.Lay the cart down on the floor so that the sides are up in a normal position. Remove the front panel by sliding it up, then remove the four large washers you used for shims. See figure 9.
SIDE | (4) LARGE |
PANEL | FLAT |
| WASHERS |
| USED AS |
| SHIMS |
CART
SIDE
PANEL
FRONT
PANEL
FIGURE 9