Aiphone AXW-AVR Configuration Diagram, KBC FPVB1-AB1-IB2-ST, AX-DMor IE/IF-Series, Axw-Avt, Ax-Dv

CONFIGURATION DIAGRAM:

AXW-AVT / AXW-AVR with KBC Networks (FPVB1-AB1-IB2-ST, FPVB1-AB1-IB2-SR), 1 of 2

Configuration Notes (1 of 2):

1.AX-series video door station connects to ‘DOOR’ input of AXW-AVT. Ensure that the “CCTV / DOOR’ switch on the AXW-AVT is in the ‘DOOR’ position.

*2. Alternatively, an IE/IF-series or AX-DM audio door may be used, along with 3rd party CCTV camera. Connect audio door station to ‘Door’ input (following the wiring method shown in the AX-series installation manual, pg. 12). Connect the camera to ‘Video In’ and put the ‘CCTV / DOOR’ switch in the ‘CCTV’ position.

Configuration Notes (1 of 2, continued):

4.When the SENSOR input is used, the door station will be turned on whenever the sensor device is activated (Normally Closed contact from 3rd party supplied device).

5.The RELAY output provides an optional Normally Open dry contact output which is activated whenever the AX-series door station is in use. This can be used to activate any device local to the AXW-AVT (DVR trigger, video switcher activation, local call indication, etc.).

3.	Connect the Call In / Call Out and Audio In / Audio Out connections on				6.	Configure AXW-AVT internal jumpers as necessary (see Pg. 21).
	the AXW-AVT to the Meridian fiber transmitter module (as detailed at						KBC: FPVB1-AB1-IB2-ST
	right, Fig. 1). For complete pin definitions, consult the Meridian
	installation document.
	AX-DM or IE/IF-Series		AXW-AVT	PS-2420UL
	Audio Door Station		24V				A+ A- GND A+ A- GND
			+	+
			-	-
			RELAY	Normally Open contact for		V1	AUDIO 1 AUDIO 2	C1	C2	C3	C4
			NO	remote device activation
			NO
				(i.e. video switcher, DVR, etc.)
			SENSOR	Normally Closed input for remote
			NC
			NC	activation
			CALL IN	(i.e. motion sensor, loop detector, etc.)						To Door
			+
			-							Release
CCTV Camera			CALL OUT
			+
75 Ohm, 1V Peak-to-peak			-
(Independently powered)			AUDIO IN
			+
			-
		*	AUDIO OUT
			+
			-

AX-DV

DOOR

CAT-5e

VIDEO IN

Coax

VIDEO OUT Coaxial Video Cable

Please Note:

Only information pertaining to the connection and operation of the AXW-AVT / AXW-AVR and listed 3rd party devices interfacing with it are included here. Aiphone is not responsible for attempts to connect the AXW-AVT / AXW-AVR to untested 3rd party transmission hardware. Consult the installation manual for the 3rd party device being utilized

for further information regarding physical mounting, base functionality, power requirements,	etc. For the most up-to-date compatibility information, please consult http://
www.aiphone.com or contact Aiphone Technical Support.
For complete AX system installation, wiring, and programming information, please consult the AX Installation Manual (included on CD with AX Central Exchange Unit, or
Pg. 15 available at http://www.aiphone.com).	Pg. 16