Aiphone AXW-AVR Configuration Diagram, AX-DMor IE/IF-Series, Axw-Avt, Audio Door Station, Ax-Dv

CONFIGURATION DIAGRAM:					Configuration Notes (1 of 2, continued):
AXW-AVT / AXW-AVR with AFI (American Fibertek) Fiber (MT/MR-89A-AX), 1 of 2					4. When the SENSOR input is used, the door
					station will be turned on whenever the sensor
AX-DM or IE/IF-Series		AXW-AVT			device is activated (Normally Closed contact
			PS-2420UL		from 3rd party supplied device).
Audio Door Station		24V
		+	+		5. The RELAY output provides an optional
		-	-
		RELAY	Normally Open contact for remote device activation		Normally Open dry contact output which is
		NO			activated whenever the AX-series door station
		NO	(i.e. video switcher, DVR, etc.)		is in use. This can be used to activate any
		SENSOR
			Normally Closed input for remote activation		device local to the AXW-AVT (DVR trigger,
		NC
		NC	(i.e. motion sensor, loop detector, etc.)		video switcher activation, local call indication,
		CALL IN			etc.).
		+
		-
CCTV Camera		CALL OUT			6. Configure AXW-AVT internal jumpers as
		+			necessary (see Pg. 21).
75 Ohm, 1V Peak-to-peak		-
(Independently powered)		AUDIO IN
		+						To AFI specified/supplied
		-
	*	AUDIO OUT						power source
		+
		-
		DOOR		Contact Contact		Audio	Video	Optical
					+		IN	I/O
AX-DV	CAT-5e			+
		VIDEO IN			-
				-	+
	Coax			+
		VIDEO OUT		-	-			12VDC
Configuration Notes (1 of 2):				Door Release/				AFI MT-89A-AX
				Contact Out (optional)
1. AX-series video door station connects to ‘DOOR’ input of AXW-AVT. Ensure
that the “CCTV / DOOR’ switch on the AXW-AVT is in the ‘DOOR’ position.
*2. Alternatively, an IE/IF-series or AX-DM audio door may be used, along with				Coaxial Video Cable
3rd party CCTV camera. Connect audio door station to ‘Door’ input (following								Optic Fiber
the wiring method shown in the AX-series installation manual, pg. 12).
								(to MR-89A-AX, Pg. 13)
Connect the camera to ‘Video In’ and put the ‘CCTV / DOOR’ switch in the
‘CCTV’ position.

3.Connect the Call In / Call Out and Audio In / Audio Out connections on the AXW-AVT to the terminal block of the AFI MT-89A-AX, as shown. For detailed terminal definitions, consult the AFI MT-89A-AX installation sheet.

Please Note:

Only information pertaining to the connection and operation of the AXW-AVT / AXW-AVR and listed 3rd party devices interfacing with it are included here. Aiphone is not responsible for attempts to connect the AXW-AVT / AXW-AVR to untested 3rd party transmission hardware. Consult the installation manual for the 3rd party device being utilized

	for further information regarding physical mounting, base functionality, power requirements,	etc. For the most up-to-date compatibility information, please consult http://
	www.aiphone.com or contact Aiphone Technical Support.
	For complete AX system installation, wiring, and programming information, please consult the AX Installation Manual (included on CD with AX Central Exchange Unit, or
Pg. 11	available at http://www.aiphone.com).	Pg. 12