Aiwa AV-X220 Manual Tuning, Direct Tuning, Press the UPA or DOWNY button to select a station

MANUAL TUNING

MONO

TUNER

POWER 1

II

DIRECT TUNING

1,2 3 DOWNY, UPA

1 Press the TUNER button repeatedly to select the desired band.

~

When the TUNER button is pressed while the power is off, the power is turned on directly.

2 Press the UPA or DOWNY button to select a station.

Each time the button is pressed, the frequency changes. When a station is received, “TUNE” is displayed for two seconds. During FM stereo reception, [[101)) is displayed.

To search for a station quickly (Auto Search)

Keep the UPA or DOWN~ button pressed until the tuner starts searching for a station. After tuning in to a station, the search stops.

To stop the Auto Search manually, press the UPA or DOWNV button.

9 The Auto Search may not stop at stations with very weak signals.

When an FM stereo broadcast contains noise

Press the MONO TUNER button on the remote control so that “MONO appears on the display.

Noise is reduced, although reception is monaural.

To restore stereo reception, press the button so that “MONO disappears.

To change the AM tuning interval

The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval.

Hold down the TUNER button and press the POWER button immediately. Note that the unit is set to the Direct Tuning mode if the TUNER button is pressed and held down for about two seconds.

To reset the interval, repeat this procedure.

When you know the frequency of the desired station, you can tune in directly to the station.

1 Press the TUNER button to select a band,

2 Press the TUNER button and hold it down until “_” flashes on the display (Direct Tuning Modle).

3 Press the appropriate numbered buttons to tulne in to the desired station.

Example:

To tune into 106.50 MHz, press 1, 0, 6, 5 and O buttons. To tune into 95.2 MHz, press 9, 5, 2 and Q buttons.

To cancel the Direct tuning mode

Press the UPA or DOWNT button.

m

●When entering a frequency out of tuning range, the vallue flashes for two seconds and then goes off. Check the frequency and repeat step 3 correctly.

●When entering a frequency not covered by the tuning interval, the value is automatically rounded up or down to the closest one covered by it.

●The DIGIT buttons on the remote control can not be used when tuning in to the desired station.

ENGLISH 10