Aiwa CDC-X30MP manual Basic OPERATION, Audio and Clock Adjustment

BASIC OPERATION, AUDIO AND CLOCK ADJUSTMENT

PWR/ATT

SEL

Jog dial (PUSH-SOURCE)

DSPL TU (TUNER)

+/-

Turning the unit on/off

•You can turn the unit on by pressing any button on the front panel except z and %. The unit also turns on when you insert a CD.

•Press and hold PWR/ATT until the unit turns off.

Note

Most operations described in this manual require the unit to be turned on before starting the operation, unless explicitly stated otherwise.

Adjusting sound

You can select the following modes for adjusting sound depending on the music you listen to: BASS (low frequencies), TRE (high frequencies), BAL (left/right), FAD (front/rear), H-BASS (high bass)*, DSSA (Drivers Sound Stage Adjustment)** and BBE***.

*You can reinforce the bass sound.

**You can adjust sound stage and tone balance to best serve a particular seat in the car.

***You can enhance the clarity of high-frequency sound.

1Press SEL repeatedly to select the mode to be adjusted.

Pressing SEL cycles through the modes. The selected mode appears on the display.

2Turn Jog dial to increase or decrease the level for the selected mode (except for H-BASS, DSSA and BBE).

In H-BASS mode, turn Jog dial to select 1, 2, 3 or OFF.

In DSSA mode, turn Jog dial to select L (for the front left seat), R (for the front right seat) or OFF.

In BBE mode, turn Jog dial to select 1, 2 or OFF.

Notes

•Adjust the level or select an item within 5 seconds, or the selected mode will return to previous state.

•When DSSA is activated, you cannot adjust BAL and FAD.

Changing the source mode

1Press Jog dial (PUSH-SOURCE).

Pressing Jog dial (PUSH-SOURCE) cycles through source modes in the following order:

F1 (F2/F3/A1/A2) → DISC* → AUX IN ↑

*“DISC” does not appear on the display when there is no CD in the unit.

Adjusting the volume

1 Turn Jog dial.

“VOL (volume)” appears on the display.

Aligning the source levels

(Source Level Adjuster)

Volume may vary each time you change the source mode. In this case, you can align each source mode’s volume to almost the same level.

1Press Jog dial (PUSH-SOURCE) or TU (TUNER) repeatedly to select the desired mode.

2Press DSPL while pressing SEL. “LEVEL 0” appears on the display.

3Turn Jog dial to adjust the level.

Note

Adjust the level within 5 seconds, or the selected mode will be canceled.

Muting the sound

1Press PWR/ATT briefly.

“ATT ON” appears on the display.

To restore volume, briefly press PWR/ATT again.

Restoring the factory settings

1Turn off the unit.

2Press and hold DSPL until “LEVEL --” appears on the display.

Note

You can restore the factory settings only for VOL, BASS, TRE, BAL, FAD, H-BASS, DSSA and BBE, and aligned source volume levels.

3 ENGLISH