PHONES \
TUNER/BAND
POWER STANDBY/ ON 6
QSOUND,
REPEAT/
MODE/SLEEP
VOL 
UP, 
DOWN
aPAUSE/SET
sSTOP/CLEAR
dPLAY/DIR/PRESET |
( cPLAY/PRESET) |
r, t (TUNING
ATUNER OPERATION
1 Press *TUNER/BAND repeatedly to select the desired band.
FM AM
The power is turned on and the previously tuned station is received.
*or BAND on the remote control (applicable when the AC cord is connected)
2 Press r, t (TUNING -, +) to select a station.
After listening, press POWER STANDBY/ON6 to turn the power off.
For better reception
FMAM
Extend the rod antenna | The antenna is inside the |
and orient it for the best | unit. Position the unit for |
reception. | the best reception. |
*REPEAT/MODE/SLEEP
-If an FM stereo broadcast contains noise, press the
button so that 
is displayed.
Noise is reduced, although reception is monaural. To restore stereo reception, press the button again.
-If a
* or MODE on the remote control
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/ step. If you use the unit in an area where the frequency allocation system is 9 kHz/step, change the interval as follows.
1Press TUNER/BAND.
2Press POWER STANDBY/ON6 while pressing
TUNER/BAND.
When the AM tuning interval is changed, the preset stations are cleared.
NOTE
If the unit picks up noise from other electrical appliances nearby, like a TV or fluorescent lights, move the unit.
For quick tuning (Auto Search)
Keep r, t pressed until the tuner starts searching for a station. When a station is tuned to, the search stops.
If the broadcast signal is weak, it does not stop. To stop the search manually, press r or t.
To listen with the headphones
Connect headphones with a stereo mini plug to the PHONES \ jack on the rear of the unit.
