Aiwa CX-NA71 manual Mixing, 3,4,5, Microphone, Vocal Fader/Multiplex Functions, jacks, =8.6?s

MICROPHONE	MIXING		m
			● When the MIC or ECHO level is changed, the SURROUND
			mode is automatically canceled.
			● If a microphone is held too near the speakers, a howling sound
	5	.’	may be produced. In this case, hold the microphone away
			from the speakers, or decrease the microphone volume.
	2		● If sound through	the microphone is extremely loud, it may be	‘
3,4,5			distorted. In this case, decrease th,e microphone volume.
			● When the function is changed, the microphone volume and the		“
	KARAOKE		echo volume are set to off.
			Recommended	microphones
	1		.The use of unidirectional type microphones is recommended to
			prevent howling. Contact your local Aiwa dealer for details.

4

Two microphones (not supplied) can be connected to this unit, allowing you to sing along to music sources.

Use microphones with mini plugs (03.5 mm, ‘/8 inch).

1 Connect your microphones to the MIC 1 and MIC

2 jacks.	-.	MIC 1 MIC 2
		0Q

,

2 Press one of the function buttons to select the source to be mixed, and play the source.

3 Adjust the volume and tone of the source.

4 Press the MIC button and turn the VOLUME control within 4 seconds to adjust the microphone volume.

The microphone volume can be selected from 1 to MAX (7) or OFF (cancel).

The volume of both microphones is adjusted simultaneously.

5 Press the ECHO button and turn the VOLUME

control within 4 seconds to adjust - the echo level.

The echo level can be selected from 1 to MAX (7) or OFF

To change the delay time of echo

Hold down the ECHO button during the echo is on.

“P (Long) and “M”(Middle) are displayed alternately. At the desired ‘position, release the button.

To record microphone sound mixed with source sound

Follow the procedure for recording from the sound source (see page 15).

The SYNC DUB button cannot be used for mixing recording.

When not using the microphones

Set the microphone volume and echo level to OFF and remove
,,.	,	‘,,	,.. !, ...,

VOCAL FADER/MULTIPLEX FUNCTIONS

This unit can use discs or tapes as Karaoke sources.

Press the KARAOKE button repeatedly to select the vocal

fader or multiplex function.

Use the vocal fader function for ordinary discs or tapes. Use’the multiplex function for multl audio discs or tapes.

Each time the KARAOKE button is pressed, one of these functions is selected cyclically.

0		@				@
		gm~S$&&m				& =F,,,,z.!...bakz- S’w-’.’
~E~q#,@E@~						.ti+~dam.!
		E=.*4; -::;,:;		q&q	~	~>e,e,,..	!	~
%%8{E,--~@+&g~ ~						~:*V* .;:
		~~m:m, ,-						!. n
,W.- .	. .-s..rs-w**!.	!$~$~i!~~~mkg$h				%sF:*”*.w=23;a#3mp$,.mlb*
qkwk$e ,sk l-q,,p,
<+#I,r,’ei%8*:~4~i7d~,L, @*.hA!*;*,B,.-*,,,!,,a,,,..						,,=~~:.,.,..,,,~===:~”~b~~afis:d;lzisze.
	!52..			@l
	.. ...* .. ; -			*~~~,~&& ,$,~,fp$~.~p~~$
	s3aw%%&a$			,wwtme+ehq~g
L	:ph;		‘-~~?+---$E3G$:<			J
	#,ka ,’” -	..-* :			V’:w
	-., ,-		*	%ti!s...$.s,q$~ul!
	---... ....=8.6?s
	...,,,,,.,= -.			a%~wf,&*:=:-~ . k=@&
	~#j@Bf~~,.		...,.&,,c
	1,,.%,,.am. .=,.....,....

oVocal Fader

The singer’s voice becomes softer than the accompaniment.

@Auto Vocal Fader

The singer’s voice becomes softer only while there is audio input through a microphone,

@Multiplex

Only the sound on the left channel is heard from both speakers, and the sound on the right channel is muted.

@Auto Multiplex

The sound on the left channel is heard from both speakers, and the sound on the right channel is muted only while there is audio input through a microphone.

To change the time lag setting in Auto Vocal Fader or Auto Multiplex function

The muted original singer’s voice can be turned faster to the normal level.

When Auto Vocal Fader or Auto Multiplex is selected, “A-VF or “AUTOMPX is displayed for 3 seconds and changes to the selected function name. After the selected function name is displayed, hold down the KARAOKE button, until FAST is disdaved.

To ‘ret;rn to the initial setting, select SLOW.
When the power is turned off, SLOW is restored.	~