OPTICAL IN VIDEO 1/OPTICAL IN VIDEO 2 jack / OPTICAL OUT jack

The OPTICAL IN VIDEO 1 jack and OPTICAL IN VIDEO 2 jack accept digital audio input from connected equipment.

The OPTICAL OUT jack outputs digital audio signals to the connected equipment.

Connect digital audio playback/recording equipment, such as an MD recorder , a DAT deck, or a CD-R deck, etc. with optional optical fiber cables.

Connect the optical input jack of the connected equipment to the OPTICAL OUT jack, and the optical output jack of the equipment

to the OPTICAL IN VIDEO 1 jack or the OPTICAL IN VIDEO 2 jack.

Before connecting the cable, remove the dust cap from the jacks. Reattach them when the jacks are not to be used.

CONNECTING AN OUTDOOR ANTENNA

For better FM reception, use of an optional outdoor antenna is recommended.

Connect the outdoor antenna to FM 75 Ω (COAXIAL) jack.

CAUTION ON CONNECTING EQUIPMENT TO THE OPTICAL OUT JACK

When connecting digital equipment without a built-in Dolby Digital or DTS decoder , do not play back Dolby Digital or DTS source with multichannel surround sound. When connecting equipment that does not comform to 96 kHz Linear PCM source, do not play back 96 kHz Linear PCM source. It may cause a high level of noise which could harm your ears and damage the speakers.

•The OPTICAL IN VIDEO 1 or 2 jack shares the same video source as the VIDEO 1 or 2 jack.

SUBWOOFER jack

This jack outputs the low frequency sounds.

Your DVD system comes supplied with a passive (non-powered) subwoofer , to be connected to the SUBWOOFER terminals , as described on page 6.

However , if you wish to connect an optional active (powered) subwoofer , connect it to this jack using an optional audio connecting cord with RCA plugs.

MOUNTING THE FRONT AND SURROUND SPEAKERS

You can mount the front and/or the surround speakers,if you want to do so.

Using wall mounting screws (not supplied)

Select a spot that will hold the weight of the speakers and carefully mount the surround speakers so that they are firmly secured.

Using a speaker mounting kit (not supplied)

The front and surround speakers are equipped with a 5 mm threaded insert on their back side. Use it to attach the ball shaft of a speaker mounting kit on the market.

Refer to the instructions of the mounting kit for further information.

PHONES jack

Connect headphones with a stereo mini plug (ø 3.5 mm,

5/32 in.).

The jack is located at the front of this unit.

 

•No sound is output from the speakers while the headphones are plugged in.

•When the headphones are plugged in, the Dolby Pro Logic surround system is canceled. The Dolby Digital or the DTS surround system automatically switches to the 2ch STEREO mode.

You can attach the speakers to the pedestal on the market with the 5 supplies screws. Refer to the instructions of the pedestal for further information.

AIWA disclaims any responsibility for injury to persons or other accidents caused by not fitting the front and/or surround speakers properly or if the place of the installation is not suitable.

8 ENGLISH